12-17-2013
I do not advise turning on any dynamic routing protocol on your server unless you know exactly what you are doing.
First of all, most servers have one network interface and do not act as a router, so they don't need a dynamic routing protocol running.
Second, for most servers on most networks an single (static) default route is all you need.
So, just asking the question begs the question of "why do you think you need to turn on RIP?"
9 More Discussions You Might Find Interesting
1. Linux
How to use NAT Router in linux Redhat 6 ? and what
packages and configuration are required ? (1 Reply)
Discussion started by: salhoub
1 Replies
2. Red Hat
:mad: I have just recently got into using Linux RedHat 9. So far I love it, I have set it up on a server I am running. Right now I have set up Samba and am running a file server for my house. I have four computers, the linux box is connected to the internet through a switch I have. There are two... (5 Replies)
Discussion started by: xTHESEUSx
5 Replies
3. Red Hat
I have just recently got into using Linux RedHat 9. So far I love it, I have set it up on a server I am running. Right now I have set up Samba and am running a file server for my house. I have four computers, the linux box is connected to the internet through a switch I have. There are two NICS in... (1 Reply)
Discussion started by: xTHESEUSx
1 Replies
4. AIX
i have AIX Unix with "dynamic routing table" service enabled, but i do not need this service. How i can disable this service.
thanks (1 Reply)
Discussion started by: jdsnbr
1 Replies
5. Linux
how i add new routes to my linux machine (1 Reply)
Discussion started by: youmna
1 Replies
6. Linux
Hello All,
I know it's a tricky probably stupid question but I'm stuck.... :(
Is there any way to route different protocols through different eth cards for the same destination in Linux? With route add or something like it?
For instance:
FTP to/from 192.168.1.1 goes through eth0 - gw2... (1 Reply)
Discussion started by: pmpx
1 Replies
7. UNIX for Dummies Questions & Answers
I am running a solaris 10 box and is just a workstation. I want to turn off the message below since it is annoying me.
Nov 15 12:16:07 stage5 in.routed: discard RIP response; source 134.56.105.2 not on interface eri0
This message only pops up when I am in a console. Telnet doesn't see it.
... (2 Replies)
Discussion started by: tecky
2 Replies
8. Programming
nmap is a network utility which gives u information about open ports on ur system. for eg
$ nmap 10.226.112.202
PORT STATE SERVICE
7/tcp open echo
13/tcp open daytime
22/tcp open ssh
23/tcp open telnet
37/tcp open time
1100/tcp open unknown
these open... (2 Replies)
Discussion started by: anand121
2 Replies
9. IP Networking
Hello. I want to Communicate 2 VLAN with router like this solution:
http://8pic.ir/images/83m0ouih8mmm9s1sfl56.jpg
For this purpose I'm configuring 2 Linux system as a switch and connect 4 host to them. Then a router is added to scenario.
The configuration of the switches is:
On DUT1(Linux):... (1 Reply)
Discussion started by: zsn
1 Replies