I doubt it'd be part of the kernel. this RHEL doc suggests quagga is what they use for it, though there's probably several options. Check what service is being used for it on the servers with lots of routes.
:mad: I have just recently got into using Linux RedHat 9. So far I love it, I have set it up on a server I am running. Right now I have set up Samba and am running a file server for my house. I have four computers, the linux box is connected to the internet through a switch I have. There are two... (5 Replies)
I have just recently got into using Linux RedHat 9. So far I love it, I have set it up on a server I am running. Right now I have set up Samba and am running a file server for my house. I have four computers, the linux box is connected to the internet through a switch I have. There are two NICS in... (1 Reply)
Hello All,
I know it's a tricky probably stupid question but I'm stuck.... :(
Is there any way to route different protocols through different eth cards for the same destination in Linux? With route add or something like it?
For instance:
FTP to/from 192.168.1.1 goes through eth0 - gw2... (1 Reply)
I am running a solaris 10 box and is just a workstation. I want to turn off the message below since it is annoying me.
Nov 15 12:16:07 stage5 in.routed: discard RIP response; source 134.56.105.2 not on interface eri0
This message only pops up when I am in a console. Telnet doesn't see it.
... (2 Replies)
nmap is a network utility which gives u information about open ports on ur system. for eg
$ nmap 10.226.112.202
PORT STATE SERVICE
7/tcp open echo
13/tcp open daytime
22/tcp open ssh
23/tcp open telnet
37/tcp open time
1100/tcp open unknown
these open... (2 Replies)
Hello. I want to Communicate 2 VLAN with router like this solution:
http://8pic.ir/images/83m0ouih8mmm9s1sfl56.jpg
For this purpose I'm configuring 2 Linux system as a switch and connect 4 host to them. Then a router is added to scenario.
The configuration of the switches is:
On DUT1(Linux):... (1 Reply)