I am triying to run this script in order to find the pid for each open port and when I run it in one server it give me an error and for another server is not showing the same error. Below I pasted the script and the result.
script
output for one server
output for other server
I think this is relate with permitions.
Thanks and regards
Last edited by vbe; 09-12-2013 at 12:59 PM..
Reason: code tags...
Hello everyone,
while setting up the Horde framework on OpenBSD 3.0, I discovered the following error:
configure: error: Cannot find rfc822.h. Please check your IMAP installation.
*** Error code 1
Stop in /usr/ports/www/php4 (line 1703 of /usr/ports/infrastructure/mk/bsd.port.mk).
***... (1 Reply)
Hi Guys,
could you help me with this.
I need a script where if we enter the hostname and range of port numbers, the script must be able to give me the ports that were unassigned to any of the services installed.
Thanks,
Charan (5 Replies)
Dear all,
good day.
i'm asking about how to disable <control>-c or <control>-z in the beginning of a shell script then enable it again before the script exit
Best Regards
---------- Post updated at 04:41 AM ---------- Previous update was at 04:18 AM ----------
Dear All
i found the... (3 Replies)
Hi,
I'm in need of a script that can monitor a list of 12 ports.. If one of the ports isn't in listening mode then email me..
The list of ports are 26401 - 26412.. (6 Replies)
Hello
I am trying to install fftw3.3.3 on an HPC system. The system has openmpi installed ( though we can choose between a variety of mpi distributions). However, while ./configure step of fftw, there is an error. The relevant section of the output is:
checking whether to build shared... (3 Replies)
Bash on Oracle Linux 6.3
I have a shell script whose output I want to redict to a log file. So, I can simply redirect the output as shown below.
# cat myscript.sh
#### I actually want some logging mechanism here which will redirect the output to a log file
echo 'hello world'
#... (3 Replies)
Hello there .
I have a unix box 5.0.06 , this is the error (Socket: All ports in use ).
Can anyone tellme how to resolve this problem.:(
Thanks a lot . (4 Replies)
Hi
I am exactly according to this link
CentOS 6 - Apache httpd - Enable Userdir : Server World
I Enabled userDirectory
Server version: Apache/2.2.15
CentOS release 6.8 (Final)
But Iget this Error
Forbidden
You don't have permission to access /~mn/index.html on this server
Goal... (2 Replies)
I have a bash shell script, within it i am using the below two commands . its failing right on scl enable command itself.
if i run it by itself without a shell, it works fine.
by default it is using pythin version 2.6 something. i want to use 3.4 version for that reason with in the shell... (3 Replies)