cat .servers | while read LINE; do
ssh jason@$LINE $1
done
exit 1
./command.ksh "ls -l ~jason"
Why does this ONLY iterate on the first server in the list? It's not doing the command on all the servers in the list, what am I missing?
Thanks!
JP (2 Replies)
Hi unix gurus,
I am facing problem with chown command. I am not able to change the owner of any file in my home. It gives error "not owner", though I own the file(as ls shows). What could be the reason? Is it possible that usage chown can be disabled for users.
$
$ ls -l
total 2... (10 Replies)
Howdie everyone...
I have a shell script RemoveFiles.sh
Inside this file, it only has two commands as below:
rm -f ../../reportToday/temp/*
rm -f ../../report/*
My problem is that when i execute this script, nothing happened. Files remained unremoved. I don't see any error message as it... (2 Replies)
I've created a Perl daemon that needs to send an email when an error/shutdown occurs. I use the Perl Email::Valid module and that uses sendmail. When I run the script as a regular user, the email is sent with no issues. When I run the script as the root user, I get the following message in... (1 Reply)
Hello, and here's my problem:
I can't get my function to do what I want. When I call my function get_from_A_to_F I give it an argument $remainder. I want my function to substitute a number higher than 9 to a specific letter. If the argument is equal to 10 than it should change it to "A".... (8 Replies)
Hi,
I am using korn shell.
until ]
do
echo "\$# = " $#
echo "$1"
shift
done
To the above script, I passed 2 parameters and the program control doesn't enter inside "until" loop. If I change it to until ] then it does work.
Why numeric comparison is not working with -ne and works... (3 Replies)
Hello
I have a shell script that is run as root. Script rins ok until the point where it have to switch to user "mqm" to run other commands. It just hangs at the point of this line in the script
su - mqm -c "dspmq"
I ran the same commands at the terminal and they run fine.
Any thoughts. (6 Replies)
Discussion started by: mo12
6 Replies
LEARN ABOUT ULTRIX
systemd-volatile-root.service
SYSTEMD-VOLATILE-ROOT.SERVICE(8) systemd-volatile-root.service SYSTEMD-VOLATILE-ROOT.SERVICE(8)NAME
systemd-volatile-root.service, systemd-volatile-root - Make the root file system volatile
SYNOPSIS
systemd-volatile-root.service
/lib/systemd/systemd-volatile-root
DESCRIPTION
systemd-volatile-root.service is a service that replaces the root directory with a volatile memory file system ("tmpfs"), mounting the
original (non-volatile) /usr inside it read-only. This way, vendor data from /usr is available as usual, but all configuration data in
/etc, all state data in /var and all other resources stored directly under the root directory are reset on boot and lost at shutdown,
enabling fully stateless systems.
This service is only enabled if full volatile mode is selected, for example by specifying "systemd.volatile=yes" on the kernel command
line. This service runs only in the initial RAM disk ("initrd"), before the system transitions to the host's root directory. Note that this
service is not used if "systemd.volatile=state" is used, as in that mode the root directory is non-volatile.
SEE ALSO systemd(1), systemd-fstab-generator(8), kernel-command-line(7)systemd 237SYSTEMD-VOLATILE-ROOT.SERVICE(8)