Thinking of using our San for network backups..
Have a Netra 240 being installed and planning to get some space on our San.
Do you know what software is used to access the San from my server or what I would need to do? I know how to connect to local storage, disk arrays etc but not sure what... (1 Reply)
Hi,
I have an existing SUN server that has a SAN storage installed on it. It also has softwares like Appwrox(scheduler), Taradata (database client), Samba Share and a few more installed on it.
Now suppose that I have a new unix server server and i switch the same SAN store from the old unix... (1 Reply)
I have 3 SAN disks of 1 TB each. Is it more efficient to make 1 large Volume group with multiple LV's or 3 Volume Groups with 1 LV each. The SAN disk is where all my backups will be dumped.:confused: (1 Reply)
HI all,
I had recently change the Server storage from EMC to the IBM SAN.
but after the configuration, the IBM success to see the server HBA port and successfully assign a LUN for the server.
When i go to the server, and restarted it. i use the "format" command to check, but din see any... (1 Reply)
hi guys
I installed Centos 5.5 (local disk). I am using 2 HBAs
Now I mapped 5 LUNs from a Storage.
I will be using LVM
just to test I assigned a LUN I've read I have to use multipath to avoid my Centos see the LUN twice
I enabled mdmpd and multipathd...
something else I should do?
... (8 Replies)
Hi,
We are planning to setup a 10gR2 RAC and storage on ASM. We use Sun StorEdge SAN.
The installation and configuration manual says to configure ASM diskgroups with raw devices (preferably raw disk not volumes).
I dont really know if its possible to present raw disks to the Solaris... (4 Replies)
hi all,
I am on solaris 10 1/13 and new to SAN storage.
I am required to connect to the LUNs on the SAN storage and is asked to provide the WWN information to the storage administrator.
Right now, it will be just 1 connection from a single hba port to the FCport on the storage directly,... (1 Reply)
Discussion started by: javanoob
1 Replies
LEARN ABOUT OSF1
acl_copy_entry
acl_copy_entry(3) Library Functions Manual acl_copy_entry(3)NAME
acl_copy_entry - Copies an ACL entry
LIBRARY
Security Library (libpacl.a)
SYNOPSIS
#include <sys/acl.h>
int acl_copy_entry( acl_entry_t src_d, acl_entry_t dest_d);
PARAMETERS
Specifies the working storage internal representation ACL entry to copy. Specifies the location to copy the working storage internal rep-
resentation ACL entry to.
DESCRIPTION
NOTE: This function is based on Draft 13 of the POSIX P1003.6 standard.
The acl_copy_entry() function copies the contents of the individual ACL entry indicated by the src_d parameter to the individual ACL entry
indicated by the dest_d parameter. Any ACL descriptor referring to the ACL entries in either parameter will still refer to the same ACL
entries. This function overwrites the contents of the ACL entry indicated by the dest_d parameter.
RETURN VALUES
Upon successful completion, the acl_copy_entry() function returns a value of 0 (zero). Otherwise, a value of -1 is returned, and errno is
set to indicate the error.
ERRORS
If the following condition occurs, the acl_copy_entry() function sets errno to the corresponding value: The src_d parameter or the dest_d
parameter does not refer to a valid ACL entry.
RELATED INFORMATION acl_create_entry(3), acl_get_entry(3)
Security delim off
acl_copy_entry(3)