Sponsored Content
Operating Systems Solaris Netra 440 maintenance light on Post 302725945 by Kannan86 on Saturday 3rd of November 2012 02:42:55 AM
Old 11-03-2012
Nettra 440 Maintenance Light

Hi DouggieC,

As checked with logs and environment output, regarding Hardware there is no failure found.

Try for resetsc..it will reset the SC Card to default factory sets.. if its not worked...

SC Version is too low. Once u updated the SC Version maintenance light will be cleared...SmilieSmilie

Kindly confirm once u done the activity.

Rgds,
Kannan
 

7 More Discussions You Might Find Interesting

1. Solaris

440 MHz problems in UltraSparc 5 Computer

Hi all, I recently purchased a 440 MHz processor module for my Sun Ultrasparc 5 computer. I installed the module, updated the boot prom to the most recent version and when the machine starts up the initial white screen shows I have a 333 MHz processor installed ! I checked the details of the... (2 Replies)
Discussion started by: usparche
2 Replies

2. Solaris

Netra V440 & Netra 1290 keyswitch

Hello, I wrote a script which monitor the keyswitch state repeatedly each 10 minutes. I'm extracting the keyswitch status by using prtdiag. The script works fine for Netra v440 , but I found that prtdiag under Netra 1290 don't give keyswitch status. unlike Netra 440 server , I found that... (2 Replies)
Discussion started by: Alalush
2 Replies

3. Solaris

Hardware error in Netra 440 server

Dear All I am getting these error while I boot the Netra 440 server. Could anyone tell me what can be the problem Regards Copyright 2004 Sun Microsystems, Inc. All rights reserved. Use is subject to license terms. Sun(tm) Advanced Lights Out Manager 1.5.4 (indcc01ma02) ... (6 Replies)
Discussion started by: amity
6 Replies

4. Solaris

netra 440 - alom connection appears dead?

Hi All, I'm trying to telnet to my alom port, as I need to drop the box & carry out some changes in single user. But the connection appears to be dead. I get this far: Connected to server1-co Escape character is '^]'. and the connection just appears to hang there. I can ssh to the box... (1 Reply)
Discussion started by: badoshi
1 Replies

5. Solaris

errors on Netra-440: "IPC Warning: ipc: tcp_protocol: bad magic number"

I was asked to look into a problem with a Sun Netra 440 in another department. On the server in question, the relevant 'uname -a' information is, "SunOS host1 5.9 Generic_118558-16 sun4u sparc SUNW,Netra-440". That information aside, while the other admin is logged into the ALOM, these errors are... (0 Replies)
Discussion started by: Borealis
0 Replies

6. Solaris

part number for netra 440 dvd w

Hi i am accessing the server remotly. i want to replace bad dvd writer. how do i know the part number of the dvd drive for raising a spare. thanks (3 Replies)
Discussion started by: sunnybee
3 Replies

7. What is on Your Mind?

A little light entertainment... ;oD

New O'Reilly books... URL: New O'Reilly books - Album on Imgur I'll bet many of you have come across a few of these... ;oD (0 Replies)
Discussion started by: wisecracker
0 Replies
PCCARD(4)						   BSD Kernel Interfaces Manual 						 PCCARD(4)

NAME
pccard -- PC Card bus driver SYNOPSIS
device pccard DESCRIPTION
The pccard driver implements the PC Card bus. The pccard driver supports all PC Card bridges in the system. TUNABLES
The driver supports the following tunable parameters, which may be added to /boot/loader.conf or set via the sysctl(8) command: hw.pccard.debug Non-zero values cause more verbose information to be printed when a 16-bit PC Card is inserted or removed. hw.pccard.cis_debug Non-zero value causes the CIS parsing of the 16-bit PC Card to be much more verbose and include a complete CIS dump. FILES
/dev/pccard0.cis This exclusive-use device will report all the CIS chains present in a PC Card, if a 16-bit PC Card is inserted in the slot. Only one user at a time may access the CIS. The CIS is presented as the relevant byte stream from the PC Card. For CIS tuples in Attribute Memory (the default), only the even locations are presented (the ODD locations are undefined per the standard). For CIS tuples in Common Memory, every byte is presented to the user. Decoding of the CIS tuples is done via a userland program. All tuples are presented to the user. SEE ALSO
cardbus(4), pccbb(4) PC Card Standard, Release 8. BSD
July 9, 2002 BSD
All times are GMT -4. The time now is 12:04 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy