Sponsored Content
Full Discussion: LVM mirror creation problem
Top Forums UNIX for Advanced & Expert Users LVM mirror creation problem Post 302675291 by alister on Sunday 22nd of July 2012 04:52:13 PM
Old 07-22-2012
Thank you for following up with your solution. It may help someone else.

Regards and welcome to the forum,
Alister
 

10 More Discussions You Might Find Interesting

1. HP-UX

Configure DNS,NFS,NIS,LDAP and LVM(mirror,sparing and multipathing)

Hello All, I am a newbee in HP UX wanted to know how to configure DNS,NFS,NIS,LDAP and LVM(mirror,sparing and multipathing) in HP UX 11iv2 and v3 and i did go through some of the docs on hp.com but i think those are for experience UX users and i am new to this so if some one could just mention... (1 Reply)
Discussion started by: coolsami
1 Replies

2. UNIX for Advanced & Expert Users

LVM problem

hi friends I have a problem .. actually I m working on LVM in linux through WinHex ..I have made one volume group and it has two logical volumes logvol00 and logvol01 and both are respectively mount on /rahul and /rock..I have found both folder(rahul & rock) in root directory which use ext file... (1 Reply)
Discussion started by: Rahul chauhan
1 Replies

3. AIX

Partition offset problem after re-mirror vg

We had a mirrored disk failed (not the rootvg), there are 3 lvs (transfer, applogs, arch) from extvg gone open/stale state. After replaced failed disk and run cfgmgr, the new replaced disk is visible: ) I did the following to re-mirror new disk: # extendvg prodvg hdisk3 # lspv (got new pvid on... (2 Replies)
Discussion started by: jalite19
2 Replies

4. Linux

LVM - break mirror taking out orignal copy

Hi Guys, I have a mirrored LVM volume, and wish to break the mirror leaving only copy1 (effectively removing copy 0). Here's the config: # lvs -a -o +devices lvdata vg01 mwi-ao 2.19T lvdata_mlog 100.00 lvdata_mimage_0(0),lvdata_mimage_1(0) vg01... (0 Replies)
Discussion started by: badoshi
0 Replies

5. HP-UX

What is the difference between DRD and Root Mirror Disk using LVM mirror ?

what is the difference between DRD and Root Mirror Disk using LVM mirror ? (3 Replies)
Discussion started by: maxim42
3 Replies

6. AIX

Script Checking LVM Mirror not Working

Hi, I need to know who can I create an script in order to check server mirror in AIX. I got this script !/usr/bin/ksh # # Check if a VG is mirrored. # # lsattr -El <lvname> -a strictness -a copies # If copies=2 and scrictness=y, then VG is mirrored # # LVs are retrieved via 'lsvg -l... (5 Replies)
Discussion started by: fede_mont
5 Replies

7. UNIX for Dummies Questions & Answers

Question about lvm file creation

Hi, I have below code for disk creation disk_list=$(ls /dev/sd) for disk in $disk_list do pvcreate $i done So what my understanding is first it is checking the disk under /dev sdb,sdc,sdd,...sdz whether 25 disk are existing if not then its creating the 25 physical volume. I... (4 Replies)
Discussion started by: stew
4 Replies

8. HP-UX

Patch PHKL_31216 and PHCO_30698 HP-UX 11.11 for replace a LVM mirror boot disk

Hi, I have old server hp rp 3440 hp-ux 11.11. One mirrored disk is faulty. I need spesial patch PHKL_31216 and PHCO_30698, which give to correctly remove disk. Unfortunately I don't have access to hp support site. Please help me find it patch. regards,Andre (0 Replies)
Discussion started by: andre9
0 Replies

9. Linux

Centos 7.2 Convert single LVM to RAID Mirror Reinstall BootLoader

Hello, I am trying to convert a single-drive Centos 7.2 installation with LVM into a two-disk mdadm mirror with mrrored LVM. I was able to follow the excellent instructions at: http://www.dgoradia.com/creating-a-raid1-mirrored-on-an-existing-centos-on-lvm/and did create a two-disk mirror... (1 Reply)
Discussion started by: Clovis_Sangrail
1 Replies

10. Solaris

Mirror disk problem

Hello all, i have the mirror disk problem with SunOS 5.10. here's the message: # metastat d15 d15: Mirror Submirror 0: d16 State: Needs maintenance Submirror 1: d17 State: Okay Pass: 1 Read option: roundrobin (default) Write option: parallel... (4 Replies)
Discussion started by: rwprabowo
4 Replies
ALCC(1) 							  aMule utilities							   ALCC(1)

NAME
alcc - text based eD2k links calculator for aMule SYNOPSIS
alcc [-p] [-v] <inputfiles_list> alcc [-h] DESCRIPTION
Compute the eD2k links of all the input files given in the <inputfiles_list> (There can be one or more files). [ -p, --parthashes ] Compute and add part hashes to the computed eD2k links. [ -h, --help ] Prints a short usage description. [ -v, --verbose ] Be verbose - show also calculation steps. REPORTING BUGS
Please report bugs either on our forum (http://forum.amule.org/), or in our bugtracker (http://bugs.amule.org/). Please do not report bugs in e-mail, neither to our mailing list nor directly to any team member. COPYRIGHT
aMule and all of its related utilities are distributed under the GNU General Public License. SEE ALSO
alc(1), amuled(1), amulecmd(1), amuleweb(1), cas(1), ed2k(1), wxcas(1), xas(1) AUTHOR
This manpage was written by Vollstrecker <amule@vollstreckernet.de> aMule eD2k links calculator November 2011 ALCC(1)
All times are GMT -4. The time now is 03:38 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy