Application running too slow on Sun SPARC T5440 but run normal on sun M3000
Hi all,
I have application running on sun server T5440 4x8x1.4 GHz, 64 GB RAM, application running very slow though load average too low. when I install my application on another server SUN M3000 (One CPU 1x8x2.5GHz, 8GB RAM), application run smoothly.
Here is my server T5440 info:
Psrinfo -pv
/etc/system
Ipcs
Prstat
Prstat -mL
Vmstat
Mpstat
When my application running, some of CPU have IDLE state = 0 and hold the CPU while another CPU have IDLE state 100. I think this is my bottleneck but I cannot find any solution for solve that.
Netstat
iostat
Please help me find the bottleneck of my T5440 server?Thanks so much for all your help.
Hi ,
could you please clarify me the difference between sun sparc 32-bit and sun sparc 64-bit?
means on which processors these are supporting (pentium processors, sun sparc processors)
Regards,
Rajesh (1 Reply)
Hi grus,
has anybody tried for Sun cluster interconnect normal cable ,, I mean not interconnect .. What do u think ..does it support this ?
Not long ago I tried Veritas cluster and its interconnections work great with normal cable .. I wonder what will Sun cluster say to it :)) (3 Replies)
Hi,
We are planning to buy new server for our data center. Sun T5240 or M3000 which one have better performance, we are going to create many dt sessions in this server. So, i need your suggestions.
RJS (4 Replies)
I need to add two new hard drives of 300 GB capacity to a SunSPARC T5440 server. The server currently has two hard drives of 146 GB each.
How do I add the new drives to the existing UFS?
What are the procedures involved in setting this server with the new hard drives? I am very new to Solaris... (6 Replies)
I need a help to find the patch for solaris to fix USB drivers issue on Solaris 10. The server has a PCIE card which is not recognised by the OS. I run #fmadm faulty command which report issue and recommandation to apply the new patch. I got a reference to //sun.com/msg/PCIEX-8000-6D but... (0 Replies)
we have a SUN M3000 server.
setup as only 1 domain.
disk c0t0d0 and c0t1d0 and setup as SVM mirrors.
a few days ago disk T1 failed.
new we have replaced the disk, but can's see the disk in format.
have done cfgadm and devfsadm.
still can't access the new disk in format.
the output... (6 Replies)