Hello,
I am trying to do mirror in solaris 9. I have total 0-7 disks
4 5 6 7
0 1 2 3
Drive 0 and Drive 4 = Boot Drives
Need to Mirror following drives.
Drive 1 and Drive 5 = Need to mirror
Drive 1 was mounted on: /prod1, /prod2, /prod3, /prod4, /prod5.
Then i... (3 Replies)
I have two 72GB disks that are mirrored and mounted (/backup). I have a 18GB drive in an array I just attached to the server, which is running Solaris 9.
I need to create a new logical volume partition and make the existing mirror device (/dev/md/dsk/d34) and the array's 18GB drive a member of... (3 Replies)
Hi everyone,
Normally it always easier in Sparc machine, i can set or manually use the boot-device in NVram to boot the mirrored disk. However I have a big trouble about x86 mirror for a long time. I have been doing anything i can: search document, google, ask the others.
Recently i did as... (5 Replies)
Hello,
First of all I must say that I have 0 solaris experience and only some average linux knowledge.
One of my friends came to ask for my help today with a Solaris 8 x86 station that would not boot.
The system is a pentium 4 1.6 ghz, 1gb ram, 40 gb hdd.
When I turn it on, I get
... (3 Replies)
I am trying to install Solaris x86 using the Jumpstart server. I run the add_install_client command with appropriate options, and reboot my x86 Target box. The installation starts fine and unattended. After the installation completes and the target goes for a re-boot, it does not boot from the HDD... (9 Replies)
Hi,
Can you help me on booting x86 server configured under VxVM. Server boots fine normally from both the disks but if I try to boot server from mirror disk without starting veritas, then it does not boot.
vxplex -g rootdg dis var-02
vxplex -g rootdg dis swapvol-02
vxplex -g rootdg dis... (2 Replies)
Hi,
I have old server hp rp 3440 hp-ux 11.11. One mirrored disk is faulty. I need spesial patch PHKL_31216 and PHCO_30698, which give to correctly remove disk. Unfortunately I don't have access to hp support site. Please help me find it patch.
regards,Andre (0 Replies)
We have Proliant DL380 G2 running Solaris 9 x86
There are 6 physical disks installed which I believe are mirrored at hardware level to 3 sets to present 3 disks to the OS.
Is there any way to check the mirror status at OS level ?
I am guessing not and it may need a trip to site as we have no... (4 Replies)