is there any way to change the nic link_speed in Solaris 10? now my box is running degraded performance of the link speed as the switch is upgraded from 100m to 1000m.
i try to use command:
output: permission is denied.
is there any way to change?
Last edited by fpmurphy; 02-09-2012 at 10:10 AM..
Reason: code tags please!
Hi Folks,
I've just installed solaris 8, but i cannot add my network card.
i've reboot the box, got into the configmode, and try'd to add a network card. but it doesn't work. I can't add a ip address to the card, an error occurs. Who do i add it.
Kind Regards (3 Replies)
All,
I have a need to software change the MAC address of a NIC in a Sparc Ultra 10 - I believe there is a command that allows to do this at boot up?
Is it a missing (to me) part of ifconfig ?
If so, what is the syntax?
All replies gratefully received !
Thanks
Andrew (3 Replies)
Installed solaris 10 and now i want to connect to internet,to make work this i need to NIC drivers can some body tell me is it possible to get drivers and how to install. I am dying to get rid of this problem..please help me (1 Reply)
I have an RHEL 5 server with 2 Broadcom on-board NICs and 2 quad-port Intel NICs. After I installed the OS, the Intel NICs became eth0-7, and the onboards are eth8 and eth9. I really need the onboard NICs to be eth0 and eth1 (I have plans to later remove the quad-ports and replace them with 10gE... (1 Reply)
Hi,
I would like to know how to change the speed of ethernet card in linux? as it is showing auto-neg using mii-tool -v eth0
and my requirement is 100mbps full duplex.
Regards,
Manoj (3 Replies)
Can someone point out which steps are to be done to get information if NIC on Solaris is malfunctioned and/or not working properly.
Since my Solaris knowledge is very modest, i would apreciate any help.
OS is Solaris 10 x86
Regards.
Peasant.
---------- Post updated at 11:57 AM... (0 Replies)
Hi,
Hardware:
Mother board: Asus P5G4IC-M LX
On board NIC: PCIe Gigabite LAN
Kernel Ver.: SunOS 5.10 Generic_141445-09
I've NIC detection problem in Solaris 10. When I was trying to install in x86 machine, it was not asking for any Network settings which means it couldn't find NIC. But... (7 Replies)
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Dear all,
I have a remote CentOS7 server that has two network cards. Each card has four ports and port one of card one was defined with the IP address assigned to the server. So far, so good and it's been working for over a year. We have now got cables sorted out so there are four paths... (4 Replies)