Hi all!
I'd like to know the differences between hard links and soft links. I've already read the ln manpage, but i'm not quite sure of what i understood.
Does a hard link sort of copy the file to a new name, give it the same inode number and same rights?
What exactly should I do to do this:... (3 Replies)
Hi
PLease let me know the usage of Hard Link vs Soft Link
i.e what is the basic difference and what happens when one file is changed or deleted in both the cases???
thanks (3 Replies)
Hi Experts,
Please help me out to find out difference between a hard link and a soft link.
I am new in unix plz help me with some example commands ( for creating such links).
Regards
S.Kamakshi :) (2 Replies)
Hi guys,
Good day to all. I have a question that how to remove all unavialable soft link in one folder?
Because I moved orginal (source) folder and the soft links which I created have been not available at all. And then how do I remove the soft links in one time?
Any idea?
Thanks &... (3 Replies)
Hi ,
When installing oracle software a set of directories are created under
the home directories.
Since the home directory is usually not big , i would like to create a soft link
from the home directory to mount point with alot of free space , that way the logs will not be wriiten under the... (1 Reply)
hi
i have create a soft link using below command.
ln -s <filename> <dirmane>where file name i use is t1 and dir name was t2.
i deleted the dir t2 using command rm -rf to remove the soft link .
however again i create a file a using the name t2 and when i just try to link t1 to t2 ... (1 Reply)
I did restore from netbackup for root file system on separate slice instead of corrupted one. After restoration I found there are number of soft link issues lie
e.g
libabcxyx > /mnt/usr/lib
it should be
libabcxyz > /usr/lib
does any have solution to change symbolic link changed in... (1 Reply)
Hi All,
I tried creating a soft link with the file itself. It got created successfully.
bash-3.2$ ls -l a
lrwxrwxrwx 1 ebrigup other 1 Oct 5 19:14 a -> a
bash-3.2$
Can anyone explain what is the possible use of it. I dont see any except practically wasting an inode... (2 Replies)
Discussion started by: brij123
2 Replies
LEARN ABOUT ULTRIX
systemd-volatile-root.service
SYSTEMD-VOLATILE-ROOT.SERVICE(8) systemd-volatile-root.service SYSTEMD-VOLATILE-ROOT.SERVICE(8)NAME
systemd-volatile-root.service, systemd-volatile-root - Make the root file system volatile
SYNOPSIS
systemd-volatile-root.service
/lib/systemd/systemd-volatile-root
DESCRIPTION
systemd-volatile-root.service is a service that replaces the root directory with a volatile memory file system ("tmpfs"), mounting the
original (non-volatile) /usr inside it read-only. This way, vendor data from /usr is available as usual, but all configuration data in
/etc, all state data in /var and all other resources stored directly under the root directory are reset on boot and lost at shutdown,
enabling fully stateless systems.
This service is only enabled if full volatile mode is selected, for example by specifying "systemd.volatile=yes" on the kernel command
line. This service runs only in the initial RAM disk ("initrd"), before the system transitions to the host's root directory. Note that this
service is not used if "systemd.volatile=state" is used, as in that mode the root directory is non-volatile.
SEE ALSO systemd(1), systemd-fstab-generator(8), kernel-command-line(7)systemd 237SYSTEMD-VOLATILE-ROOT.SERVICE(8)