11-05-2011
forward a Network Device via ssh
Hey foks
my problem looks like this:
Computer 1 has two network interfaces (A and B). It's connected to computer 2 via ssh using network interface A. kann I forward network interface B to computer 2, so it shows up for example in ifconfig on computer 2? how? should i use something else than ssh?
Any ideas??
SMF
8 More Discussions You Might Find Interesting
1. Programming
HI,
I am writing a network device driver for RTL8139c card on 2.6.18 kernel ... I am facing few queries listed below
1. Can i able to at all write a driver for RTL8139C or Realtek had designed new chip for 2.6 series kernel?
2. If no then which driver file 2.6.18 uses .. Is it 8139too.c or... (1 Reply)
Discussion started by: niketan
1 Replies
2. UNIX for Advanced & Expert Users
Hello there,
I have a big problem, and I hope somebody can help me. I try to realize a port forward over three server. Here is a picture...
Client Server1 | Server2
------- ------- | -------
|...... | |...... | | |...... ... (2 Replies)
Discussion started by: Art007
2 Replies
3. IP Networking
hello i have a ubuntu ssh server that i can acess from any of my comnputers but only if they are on the same wireless network as the server. i tested trhis my tehtehring my samsung blackjack to my windows partition and installing openssh to windows it works when windows is on the wireless but no... (1 Reply)
Discussion started by: old noob
1 Replies
4. IP Networking
Thanks in advance!
Ben (1 Reply)
Discussion started by: bigben1220
1 Replies
5. Red Hat
How to monitor network device traffic using MRTG?
How can I add network devices in MRTG configuration to monitor? (2 Replies)
Discussion started by: manalisharmabe
2 Replies
6. Ubuntu
Hi,
I am new to linux stuff. I want to use linux iptables to configure rule so that all my incoming traffic with protocol "tcp" is forwarded to the "FORWARD CHAIN". The traffic i am dealing with has destination addresss of my machine but i want to block it from coming to input chain and somehow... (0 Replies)
Discussion started by: arsipk
0 Replies
7. Shell Programming and Scripting
Hello all,
Here is the explanation of my problem:
I have a cronjob that connects to a NAS to do backups from my laptop to this NAS device.
The script that I wrote does check if there is a host (the NAS) responding on 192.168.1.10 and tries to connect to it with the following command:
mount -v... (3 Replies)
Discussion started by: freddie50
3 Replies
8. Red Hat
Hi All,
Could anyone please help to resolve the below problem.
I installed RHEL5.5 in my desktop.But when i try to activate the ethernet connection then it gives me the error.
I spent 2 days for the above and go through with several suggestion found by googling. But no luck.
... (0 Replies)
Discussion started by: Tanmoy
0 Replies