Hi there
the Sunfire X4100 has a great tool that you can get to from BIOS called the configuration utility which allows you to set up Disk mirroring (RAID 1) before the OS sees it, which is great and it works a treat, however, we have a large datacentre across multiuple sites and I need to find... (1 Reply)
Hi there
I am running solaris 10 on an SunFire x4100 ...(x86 box) Could anybody tell me if there is a way I can check the firmware revision without taking the box down to do it ...eeprom doesnt give me the info I require
Cheers (0 Replies)
Hai All
I rquire a small help for Galaxy x4100 server, when we are trying to sepup
ILOM through CLI it gives following error on commitpending=true steps.
set pendingipaddress=172.21.142.158
Set 'pendingipaddress' to '172.21.142.158'
-> set pendingipgateway=172.21.142.5
Set... (1 Reply)
Hi everyone,
I have a problem which looks like very simple. My SunFire X4100 have 2 disk slots: HDD0, HDD1 and 1 hard disk. I installed OS on the hard disk at HDD0 and now i want to boot it at HDD1.
When i change BIOS and begin boot at HDD1 it reset after i chose Solaris 10 at OS selecting... (3 Replies)
I have looked all over the bios configuration to enable hardware virtualization and found nothing. Could someone tell if this server support it and if so where I go to enable that feature. By the way this is a x86 server. (0 Replies)
Hello all.
I have a requirement to install a aftermarket video card in the server, can you advise what fits? or if there is a sun riser part which convers the PCIx slot to PCIe
The unit is a standard x4100 with PCIx slots, not an M2 with the PCIe slots.
thanks (4 Replies)
Hi
I have two Sun Fire X4100 machines with Ubuntu 12.04 installed on them.
I am able to configure the Net Mgt port with an IP address and access the ILOM from the browser. I can also boot the Ubuntu installed and redirect the output.
The issue i have is that when i configure the network... (0 Replies)
Hi,
I am currently on Sunfire X4100. This server doesn't have CDROM drive. Also I can't get to the OK prompt. From my laptop, I am connected to the management port using the Cisco Blue cable.
Please advise how can I get to the OK prompt. Also the server is so loud. Will the FAN cool... (1 Reply)
I have a problem,
I have been installing Redhat Interprise Linux on X4100 M2 Server, when system is reboot after install, the server is restart (reboot) again (alias unlimited).
The bios system show message error "Multi-bit ECC Error" and "bank interleave requested but not enable"
I have... (5 Replies)
Hi,
I was trying to run a program that calls 8 processors (with max. RAM of 2 GB per processor). I want to run this program on my cluster that runs SGE. The cluster has 2 nodes, and each node has 62 cores, and 248GB/node. Currently, I use the scripts below, but the program (softx below) crashes... (0 Replies)