Sponsored Content
Top Forums UNIX for Dummies Questions & Answers find physical disk type : SAS / SATA Post 302551528 by Corona688 on Tuesday 30th of August 2011 06:19:20 PM
Old 08-30-2011
It'd help to know what your system was.
 

9 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

physical volume and physical disk.

Hello, I need explanations about physical disks and physical volumes. What is the difference between these 2 things? In fact, i am trying to understand what the AIX lspv2command does. Thank you in advance. (2 Replies)
Discussion started by: VeroL
2 Replies

2. Red Hat

sata/sas controller on redhat

Hi All, How do I verify the sata/sas controller status on my redhat 2.6? Thanks. Itik (1 Reply)
Discussion started by: itik
1 Replies

3. UNIX for Advanced & Expert Users

Using newfs to make file system on a sata disk using Acard adaptor

Hi All: I am using an adaptor between a 1TB SATA hard drive and solaris 8 box with 68 pin scsi. I use the format utility to partition the HD which works fine but when I use newfs, I get some errors. I will place them below. I have blocked and the error message is in red. Anybody got any... (1 Reply)
Discussion started by: mndavies
1 Replies

4. Filesystems, Disks and Memory

Wrong BIOS IDE Settings on a SATA disk (AHCI)?

Hello, I wanted to share an experience I had today which was quite a learning experience and perhaps useful for others who may run into the issue at some point in the future. Basically, the scenario involves a OS which was installed on a machine which hardware-wise, had a SATA Drive. The... (0 Replies)
Discussion started by: septima.pars
0 Replies

5. SCO

SATA Hard Disk support by SCO OpenServer 5.05

Is SATA hard disk is suooprted by SCO OpenServer 5.05? If No, how to couter this problem. If yes, please provide the installation steps. (2 Replies)
Discussion started by: rakeshkumar9919
2 Replies

6. Hardware

Connect SATA Laptop HardDrive to Desktop SATA Slots

Hello everybody, I need to connect a laptop 2.5 SATA hard drive to a Desktop board (which uses 3.5' SATA hard drives). I've tried the connectors and they fit excellent in the 2.5 SATA connectors. The problem is that the laptop hard drive uses 5v and the PC's power source sends 12v. So, my... (4 Replies)
Discussion started by: Zykl0n-B
4 Replies

7. Hardware

Hitachi SATA hard disk drive password locked

Hi everyone (see attachments) I bought an HP Elitebook 8460p on eBay and it came with a password-locked Hitachi hard drive which I was told is the original hard drive. I don't know the password for the drive and running the diagnostics tools I see the hard drive is healthy. I tried booting... (9 Replies)
Discussion started by: milhan
9 Replies

8. AIX

Replaced pdisk not showing up in SAS Disk Array Configuration

OSLevel: 5300-10-02-0943 System Model: IBM,8203-E4A Power 6 == Hi! I replaced a failed pdisk in the raid enclosure as follows, - rmdev -l 'pdisk18' '-d' - Replaced it. - cfgmgr (detected) - I can see the new drive, with the correct serial # lscfg -v -l pdisk18 pdisk18... (2 Replies)
Discussion started by: estrar
2 Replies

9. AIX

Power machine 720 SAS disk

Hello, I would like to check how many SAS disks and its size per disk for the whole power system. As per my understanding, if we assign the SAS controller to LPAR, then we can see the disk in lpar smitty command. How can we check from the Power machine(physical ones) as well? I think the... (5 Replies)
Discussion started by: Phat
5 Replies
HPTIOP(4)						   BSD Kernel Interfaces Manual 						 HPTIOP(4)

NAME
hptiop -- HighPoint RocketRAID 3xxx/4xxx device driver SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file: device hptiop device scbus device da Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): hptiop_load="YES" DESCRIPTION
The hptiop driver provides support for the HighPoint RocketRAID 3xxx/4xxx series of SAS and SATA RAID controllers. HARDWARE
The hptiop driver supports the following SAS and SATA RAID controllers: o HighPoint RocketRAID 4522 o HighPoint RocketRAID 4521 o HighPoint RocketRAID 4520 o HighPoint RocketRAID 4322 o HighPoint RocketRAID 4321 o HighPoint RocketRAID 4320 o HighPoint RocketRAID 4311 o HighPoint RocketRAID 4310 o HighPoint RocketRAID 3640 o HighPoint RocketRAID 3622 o HighPoint RocketRAID 3620 The hptiop driver also supports the following SAS and SATA RAID controllers that are already End-of-Life: o HighPoint RocketRAID 4211 o HighPoint RocketRAID 4210 o HighPoint RocketRAID 3560 o HighPoint RocketRAID 3540 o HighPoint RocketRAID 3530 o HighPoint RocketRAID 3522 o HighPoint RocketRAID 3521 o HighPoint RocketRAID 3520 o HighPoint RocketRAID 3511 o HighPoint RocketRAID 3510 o HighPoint RocketRAID 3410 o HighPoint RocketRAID 3320 o HighPoint RocketRAID 3220 o HighPoint RocketRAID 3122 o HighPoint RocketRAID 3120 o HighPoint RocketRAID 3020 NOTES
The hptiop driver has only been tested on the i386 and amd64 platforms. SEE ALSO
cam(4), hptmv(4) HISTORY
The hptiop device driver first appeared in FreeBSD 7.0. AUTHORS
The hptiop driver was written by HighPoint Technologies, Inc. BSD
July 5, 2013 BSD
All times are GMT -4. The time now is 01:36 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy