07-19-2011
jlliagre,
Thanks for the info. I will have to look into exclusive IP zones. Can you tell me the disadvantages of the way I do it. This way I can learn from you.
10 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Hi !
Does anyone know how can i get information about my network interface ... if it works in half or full duplex mode !!
Thx in adivance !
Witt (4 Replies)
Discussion started by: witt
4 Replies
2. UNIX for Advanced & Expert Users
Hi expert,
Need some help on network interface issue..
I have added 2 x NIC card onto the Ultra 2 system recently and configured as hme1 and hme2. I have unconfigured the onboard hme0 network interface and it was running fine till few days later, i keep recieving error messages showing hme0... (6 Replies)
Discussion started by: sc2005
6 Replies
3. Red Hat
Hi
I have installed OEL 4 on my dell XPS laptop. But when i connect the LAN cable and try to acesss internet. it does not work. the led's in the port do not blink when i plug in the cable .do i need some drivers please suggest.
Thanks
Ankur (2 Replies)
Discussion started by: ankurk
2 Replies
4. Solaris
Hi,
I have installed Solaris 10 on VMware7, When i used ifconfig -a to check network interface, it has shown lo0 as loopback interface.
Please advise how to configure network interfaces using VMware. (1 Reply)
Discussion started by: ajhal04
1 Replies
5. UNIX and Linux Applications
Hi,
I'm a italian student. For my thesis I develop a gateway with protocol 6lowpan.
For that I must access to network interface to develope my personal stack based on standard 802.15.4.
Can you help me? I need an explanation for that. (0 Replies)
Discussion started by: berny88
0 Replies
6. IP Networking
Hello,
Please what's the difference between:
AND
Thank you so much (3 Replies)
Discussion started by: chercheur857
3 Replies
7. IP Networking
Hello,
Please, how can i create a network interface with a routable IP address on linux (ubuntu) ?
AND
How can i desactivate an interface?
Thank you so much for help. (1 Reply)
Discussion started by: chercheur857
1 Replies
8. Solaris
I've one Netra 240
After changing main board and system configuration card reader, Network is not accessible any more, Network interfaces are always UP and Running even when there is no cable connected to Network interfaces.
I tried to restart and plumb/unplumb with no luck.
ifconfig -a... (7 Replies)
Discussion started by: samer.odeh
7 Replies
9. UNIX for Dummies Questions & Answers
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
Discussion started by: westmoreland
1 Replies
10. Solaris
I have a few non-globa zones running in a 10.10.xx.xx network on a machine that is on a 192.168.xx.xx network.
My goal is to allow each of the non-global zones to communicate to each other while not communicating on the 192.168.xx.xx network.
I am using the current version of Solaris 10 in... (7 Replies)
Discussion started by: BradJM
7 Replies
LEARN ABOUT PHP
datetimezone
DATETIMEZONE(3) 1 DATETIMEZONE(3)
The DateTimeZone class
INTRODUCTION
Representation of time zone.
CLASS SYNOPSIS
DateTimeZone
DateTimeZone
Constants
o const integer$DateTimeZone::AFRICA1
o const integer$DateTimeZone::AMERICA2
o const integer$DateTimeZone::ANTARCTICA4
o const integer$DateTimeZone::ARCTIC8
o const integer$DateTimeZone::ASIA16
o const integer$DateTimeZone::ATLANTIC32
o const integer$DateTimeZone::AUSTRALIA64
o const integer$DateTimeZone::EUROPE128
o const integer$DateTimeZone::INDIAN256
o const integer$DateTimeZone::PACIFIC512
o const integer$DateTimeZone::UTC1024
o const integer$DateTimeZone::ALL2047
o const integer$DateTimeZone::ALL_WITH_BC4095
o const integer$DateTimeZone::PER_COUNTRY4096
Methods
o public DateTimeZone::__construct (string $timezone)
o public array DateTimeZone::getLocation (void )
o public string DateTimeZone::getName (void )
o public int DateTimeZone::getOffset (DateTime $datetime)
o public array DateTimeZone::getTransitions ([int $timestamp_begin], [int $timestamp_end])
o publicstatic array DateTimeZone::listAbbreviations (void )
o publicstatic array DateTimeZone::listIdentifiers NULL ([int $what = DateTimeZone::ALL], [string $country])
PREDEFINED CONSTANTS
o DateTimeZone::AFRICA -Africa time zones.
o DateTimeZone::AMERICA -America time zones.
o DateTimeZone::ANTARCTICA -Antarctica time zones.
o DateTimeZone::ARCTIC -Arctic time zones.
o DateTimeZone::ASIA -Asia time zones.
o DateTimeZone::ATLANTIC -Atlantic time zones.
o DateTimeZone::AUSTRALIA -Australia time zones.
o DateTimeZone::EUROPE -Europe time zones.
o DateTimeZone::INDIAN -Indian time zones.
o DateTimeZone::PACIFIC -Pacific time zones.
o DateTimeZone::UTC -UTC time zones.
o DateTimeZone::ALL -All time zones.
o DateTimeZone::ALL_WITH_BC -All time zones including backwards compatible.
o DateTimeZone::PER_COUNTRY -Time zones per country.
PHP Documentation Group DATETIMEZONE(3)