Add this line in /etc/sysctl.d/disable-ipv6.conf (create the file if it doesn't exist):
For immediate effect run
The harder way would be to fetch the kernel sources, copying in the distributions .config file, disabling IPv6 in the config, compiling & installing the new kernel, and re-doing that every time Fedora releases a new kernel package.
Hello, evertime I browse around on a site with Konqueror It gives me the old page sort of, I have to refresh the page and then it gives me the new version of it.It's geting kind of annoying now, I've cleared the cache/cookies and it still does it. Anyone know how I can fix this?:confused: :( (2 Replies)
I am trying to capture the ipv6 packets through pcap utility.
For that i am redirecting the ipv6 packets to the loopback address , but the ipv6 packets are not getting redirected to tha loopback address.Instead they are taking there normal routes. (1 Reply)
Hi all Expertise,
I have following issue to solve,
SSL / TLS Renegotiation DoS (low) 222.225.12.13
Ease of Exploitation Moderate
Port 443/tcp
Family Miscellaneous
Following is the problem description:------------------
Description The remote service encrypts traffic using TLS / SSL and... (2 Replies)
Guide on how to disable ipv6 for Centos and RedHat
1) Edit /etc/sysconfig/network-scripts/ifcfg-eth0 and change:
NETWORKING_IPV6=yes to NETWORKING_IPV6=no
2) Edit /etc/modprobe.conf and add these lines:
alias net-pf-10 off
alias ipv6 off
3) Stop the ipv6tables service:
... (0 Replies)
I've new installed Solaris 11 on Sparc T4-1.
I'd like to disable IPv6 but with no luck.
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
net0: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet... (6 Replies)
Hi,
I have created a bonding bond1 interface with 6 Eth , mode=4. Recently i have changed my old ipv6 to new one and tried to restart as well as reload network service. Post which i can see old as well as changed ipv6 in ifconfig command output. Below are few files and command output for your... (1 Reply)