Linux detected my modem(finally!) and I then proceeded it to configure it with Minicom according to the instructions here. I got it configured, and can dial up to my ISP, but now I am trying to figure out how to get Lynx to use the connection. Any ideas? (3 Replies)
hello everyone!
i am interested in SurfSolo, from Encryption Software, Anonymous Web Surfing, Computer Firewall
it is a like VPN but for personal use, has any of you tried it yet and if yes do you have any suggestions and opinions about it?
thanks (0 Replies)
I feel like the true definition of a newb but I guess you gotta start somewhere. I installed Gentoo on my laptop yesterday, it's a gnome based environment and I cannot get any wireless internet. The iwconfig and net-setup commands are not being recognized. I'm not sure what the problem is, I've... (1 Reply)
I am trying to connect a Solaris 10 PC to the internet via a Linksys router and a cable modem. I have tried following suggestions in one of the posts here for manual setup but so far no luck.
Does the Solaris 10 install for x86 automatically pick up the internet connection?
Dave :>) (4 Replies)
I had a strange problem.Recently, I virtualized my RHEL 5 system by installing Fedora 8 as guest operating system. The installation went fine. But, after installation my internet connection stopped working. Any suggestions?. I was on TataIndicom wireless USB modem. I haven't had any problems with... (3 Replies)
Hi,
I am using VMWARE and when I have the network connection set to NAT and the VM set to DHCP I get internet connection. But when I set the connection to BRIDGED and assign a static IP address I loose internet connection. I have used netconfig to manually assign the IP Address, GATEWAY, and... (5 Replies)
Dear Friends,
I have the following problem, when there is no internet does not work the ftp to the server, with the local network
use a router for dhcp
SCO OpenServer 6.0
terminals with windows 7
ftp client ftplite
and also use ftp from ms-dos
to do?
regards (1 Reply)
Discussion started by: Edgar Guevara
1 Replies
LEARN ABOUT MINIX
resolvxc
RESOLV.CONF(5) File Formats Manual RESOLV.CONF(5)NAME
resolv.conf - Domain Name System resolver configuration
SYNOPSIS
/etc/resolv.conf
DESCRIPTION
The /etc/resolv.conf is used to configure how the host will use the Domain Name System to resolve hostnames to IP addresses. It may con-
tain these two lines:
nameserver IP-address
domain domain-name
The nameserver entry tells the IP address of the host to use for DNS queries. If it is set to 127.0.0.1 (which is the default) then the
local name daemon is used that may use the /etc/hosts database to translate host names. You normally only need a nameserver entry if the
name server is at the other side of a router. The default nonamed name server can't look beyond the local network.
The domain entry tells the default domain to use for unqualified hostnames. This entry is usually not given in which case the domain of
the local host is used.
The long version of this story can be found in resolver(5).
FILES
/etc/resolv.conf DNS resolver configuration file.
SEE ALSO resolver(5), hosts(5), nonamed(8), boot(8).
AUTHOR
Kees J. Bot (kjb@cs.vu.nl)
RESOLV.CONF(5)