I'm having this error when I do full fs cleanup
# fsck -F vxfs -o full /dev/vg01/lvol1
vxfs fsck: file system had I/O error(s) on meta-data.
log replay in progress
vxfs fsck: file system had I/O error(s) on meta-data.
vxfs fsck: file system had I/O error(s) on meta-data.
pass0 - checking... (2 Replies)
I am using raidctl on a v440 disk and noticed it resyncs after every boot, which takes about 30 minutes because of the size of the partition. I am concerned with what happens during the resync if "writes" happen to the disk before it is complete?
Any info would be helpful.
Thanks (0 Replies)
Hey peeps,
Here is somethin u might find interestin....
Is it possible to recover data from a partition which used to be an ext3 file sytem with some nice forgotten backups, which now is an lvm partion containg root partition of another OS. :)
I couldn't create any mess better than this, can... (2 Replies)
Hi All,
I am writing a block driver for a 2GB SD card where i get the total amount of data per request as follows:
struct request *req;
uint card_addr,total_bytes;
struct request_queue *rq = BlkDev->queue;
req = elv_next_request(rq);
..
..
card_addr = req->sector*512;... (1 Reply)
Hi,
could any one tell is there any test-suite or any idea How to do data corruption validation testing, means there is no any data corruption ?
Regards
Manish (1 Reply)
Hi,
In order to have a sand box machine that I could use to test some system changes before going to production state, I'd like to duplicate a working system to a virtual one. Ideally, I'd like to manage to do it this way :
- Make a full system backup excluding the user file system (this... (7 Replies)
In my infinite lack of wisdom, I brought a Solaris 10(Sparc, 64 bit ) system down to init 1, detached a metadrive so that I could run format->analyze->refresh on it, and then reinit'd and reattached it .
It started syncing the drive as it's a submirror of a mirrored drive, which happens... (8 Replies)
/tmp/man18809436: Invalid file system control data detected
Help me
what do I do?
Если знаете русскии, пишите на нем. (2 Replies)
Discussion started by: islily
2 Replies
LEARN ABOUT DEBIAN
rdiff
rdiff(1) General Commands Manual rdiff(1)NAME
rdiff - compute and apply signature-based file differences
SYNOPSYS
rdiff [options] signature old-file signature-file
rdiff [options] delta signature-file new-file delta-file
rdiff [options] patch basis-file delta-file new-file
USAGE
You can use rdiff to update files, much like rsync does. However, unlike rsync, rdiff puts you in control. There are three steps to
updating a file: signature, delta, and patch.
DESCRIPTION
In every case where a filename must be specified, - may be used instead to mean either standard input or standard output as appropriate.
Be aware that if you do this, you'll need to terminate your options with -- or rdiff will think you are passing it an empty option.
RETURN VALUE
0 for successful completion, 1 for environmental problems (file not found, invalid options, IO error, etc), 2 for a corrupt file and 3 for
an internal error or unhandled situation in librsync or rdiff.
SEE ALSO librsync(3)AUTHOR
Martin Pool <mbp@samba.org>
The original rsync algorithm was discovered by Andrew Tridgell.
rdiff development has been supported by Linuxcare, Inc and VA Linux Systems.
$Date: 2002/01/25 21:25:34 $ rdiff(1)