Top header says 50% free, but table shows 100% used
Hi,
Can anyone explain this?
There are many more lines of top results, adding up to well over 100%. Due to decent performance, I'm assuming the values in the header section are correct, but why the discrepancy? It is a VPS, if that's relevant.
When I run the top command, it shows 1 process as being Stopped. This is not a zombie, but simply a stopped process. Unfortunately, I can't figure out how to tell which process this is, nor why it is in a stopped state? Any way of finding this out? (7 Replies)
Now, I had installed free bsd at my office. Unfortunitely, Email server have been using Local PoP3 and SMTP to our ISP with outlook. but my unix firewall sever ( free bsd ) didn't allow these port ( 110 & 25 ).
How can i create the IP table to pass at server. If u have any experience about obvious... (4 Replies)
Hi Gurus,
For a particular slice I have change the minfree from 10% to 1% with tunefs -m and its allowing the creation of file on that slice, however when I am seeing the same with df -k it says that the slice is 100% full.
What could be reason for this?
Thanks (2 Replies)
hi,
I want to extract and save the cpu(s) information from top command output, but individual cpu statistics separately on a multi-processor machine.
In command line, top will show this statistics when we press the switch "1".
any ideas?
thanks,
meharo (3 Replies)
Hi Export,
i execute 'top' command to show the free memory in Solaris host, but the read is much lower than the RSS value shown in prstat command. Which one can reflect the real status and it is possible the difference caused by any patch of OS?
Top command (only 883 memory is free)... (3 Replies)
I have a Script that generates 3 columns of the result. The line script is
/usr/xpg4/bin/awk -F' ' '{print $1 /t $2}' File_Name | awk -F'>' '{print $2}' | cut -d'<' -f1 | sort -rn | uniq -c
The output of the Command is :
Code.500 4 Input Error
Code.404 ... (4 Replies)
Hi,
When I run the free command on solaris, I get the following:
"Memory: 60G phys mem, 69G free mem"
Q: how cna the free mem be higher then the physical mem?:confused:
Amit (3 Replies)
I'm trying to take mrt output and put it at the top of a file along with the date and time. I was able to do it at the bottom of the file with the following
printf "********** $(date) **********\n\n" >> $OUTPUT_PATH/$HOSTNAME
mtr -r -w -c 10 $HOSTADDRESS >> $OUTPUT_PATH/$HOSTNAME
printf... (2 Replies)