03-20-2011
The most obvious difference is the architecture change. Is your application available for Solaris on x86 ?
5 More Discussions You Might Find Interesting
1. Solaris
hi, i am trying to install solaris 10 (on 4 cd's downloaded from the sun website) on my dell poweredge 2800 server. 2 xeon processors, 2GB of RAM and 2 NICS, 73 GB SCSI (maxtor ultra320, 3.5 series), i can give more details on request...
the installation crashes when trying to detect the NICS... (0 Replies)
Discussion started by: xinugeek
0 Replies
2. Filesystems, Disks and Memory
Does anybody no how to get around the fact that the Red Hat installation does not see the SCSI hard drives. It lets you manually pick the proper device, but still fails saying no drive detected (or something to that effect). I was going to install windows 2003 Server and use VMware...but again,... (1 Reply)
Discussion started by: Fatflea
1 Replies
3. UNIX for Dummies Questions & Answers
Hi
I have experienced some problems with the new monitor on my Solaris WS (Solaris5.4). Old monitor (Sony ES200) died an we installed a new one (Dell Ultrascan P780)
The system booted but the monitor statrted blinking at the rate about once in 5-7 seconds. This is espetially strange that the... (0 Replies)
Discussion started by: Andrey Malishev
0 Replies
4. Solaris
Hello,
i am trying to get following configuration up running, but get no access to the library roboter.
Server: SunOS 5.10 Generic_138889-03 i86pc i386 i86pc
DELL TL-2000: 1 Tape: IBM ULT3580-HH4 and Robot: 3573-TL,
connected via ISCSI Bridge (build into the TL)
... (1 Reply)
Discussion started by: austin73
1 Replies
5. Solaris
Hi,
I am about to try Solaris 10 on a dell power edge 1950 server. I have googled and found some articles(2007) saying its not supported. Anybody tried this recently?
Thanks in advance (2 Replies)
Discussion started by: ./hari.sh
2 Replies