03-15-2011
Look in /etc/conf/pack.d/usb_prnt
Not that I have tried this, but I think that if you create the source code and place it in the correct directories, all below /etc/conf, then re-linking the kernel will automatically compile and link the driver.
Run scoadmin->hardware-kernel-manager->relink
4 More Discussions You Might Find Interesting
1. Solaris
I've been researching minimizeing Solaris 8 and found that on the web page http://www.sun.com/bigadmin/content/packagelist/s8u7PkgList/p2.html the package SUNWglmr
is listed as "rasctrl environment monitoring driver for i2c, (Root) (32-bit)" while in the document "Solaris 8 minimize-updt1.pdf"... (1 Reply)
Discussion started by: roygoodwin
1 Replies
2. UNIX for Advanced & Expert Users
Hi All,
I have a device driver that uses UARTserial port to write/read to-from a device.
That device driver is working fine on FC3 machine( kernel version 2.6.12)...
Now I am switching to FC9 (kernel version 2.6.25.11-97).I have changed the interrupt flag SA_INTERRUPT to IRQF_DISABLED... (0 Replies)
Discussion started by: rajuprade
0 Replies
3. Programming
Hi All,
I have a device driver that uses UARTserial port to write/read to-from a device.
That device driver is working fine on FC3 machine( kernel version 2.6.12)...
Now I am switching to FC9 (kernel version 2.6.25.11-97).I have changed the interrupt flag SA_INTERRUPT to IRQF_DISABLED... (0 Replies)
Discussion started by: rajuprade
0 Replies
4. UNIX for Advanced & Expert Users
Can anybody get me some sample driver code of linux block drivers to send request to scsi disks?
Basically I need a sample code of linux scsi block driver.
I tried googling for sample code but did not find it. (1 Reply)
Discussion started by: rupeshkp728
1 Replies
SMSC(4) BSD Kernel Interfaces Manual SMSC(4)
NAME
smsc -- USB SMSC LAN9xxx Fast Ethernet driver
SYNOPSIS
To load the driver as a module at boot time, place the following line in loader.conf(5):
if_smsc_load="YES"
Alternatively, to compile this driver into the kernel, place the following lines in your kernel configuration file:
device uhci
device ohci
device usb
device miibus
device smsc
DESCRIPTION
The smsc device driver provides support for USB Fast Ethernet adapters based on the SMSC LAN9xxx chipsets.
For more information on configuring this device, see ifconfig(8).
HARDWARE
The following devices are supported by the smsc driver:
o SMSC LAN9500, LAN9500A, LAN9505 and LAN9505A based Ethernet adapters
o SMSC LAN89530, LAN9530 and LAN9730 based Ethernet adapters
o SMSC LAN951x Ethernet adapters with integrated USB hub
SEE ALSO
arp(4), intro(4), miibus(4), netintro(4), usb(4), ifconfig(8)
HISTORY
The smsc device driver first appeared in FreeBSD 10.0.
AUTHORS
The smsc driver was written by Ben Gray <bgray@FreeBSD.org>.
BSD
September 26, 2014 BSD