|
|
Sponsored Content
Operating Systems
AIX
AIX 5.3 Boot Hangs On Power4 Hardware
Post 302496649 by zxmaus on Monday 14th of February 2011 08:10:37 PM
02-14-2011
Moderator
if you have a display as long as you are in sms menu, try to select the correct console ... than try the whole thing again. Usually it gets dark when you see the welcome display because there is no console / tty defined.
BTW - if its power4 I would guess its rather a 650/670 than a p5**
Regards
zxmaus
BTW - if its power4 I would guess its rather a 650/670 than a p5**
Regards
zxmaus
|
|
10 More Discussions You Might Find Interesting
1. AIX
Hai
I am new to AIX, currently in our shop we use AIX 4.3.3 , where we have hosted the websphere 3.5 applicaiton on it. The AIX server is getting hanged very frequently, when analyse we found the swap memory is increasing once it reaches the memory 100 the system is totaly in hung state, so... (5 Replies)
Discussion started by: vipin77
5 Replies
2. AIX
Can anyone let me know the output of command 'uname -aL' on AIX 5.1 POWER4 support? (6 Replies)
Discussion started by: arnab84
6 Replies
3. AIX
I've got an RS6K B50, and i've installed AIX 5.3, TL5. It installs fine, the only customisations i make to the BOS are to change the locale / keyboard layout to UK, and to choose not to install graphical software.
I have no video card in this box, and i connect via a serial console (null modem... (4 Replies)
Discussion started by: craigp84
4 Replies
4. Solaris
Hi all,
I have a SUN server Sun-Fire-V890 running solaris 9, with a remote system console .
Both the IP adresses of the server and the console are in a private network (address 10.67.xxx).
For some reasons I need to give the access to the server from outside address 194.xxx, but I prefer that... (2 Replies)
Discussion started by: aribault
2 Replies
5. AIX
Hi guys,
Got a tiny bit of a problem on one of our servers here at work. I installed AIX 5.3 on the server and that went fine. Then I upgraded to ML 5300-05-01, but now the system just hangs on boot.
The system starts up and the monitor comes on in few minutes, but a few seconds later when... (6 Replies)
Discussion started by: drchris
6 Replies
6. AIX
To All:
I have this AIX machine (see boot process below). The problem was it hangs at:
The ctrmc Subsystem has been started. Subsystem PID is 11906..
I checked with other forums but their advise were just "strong punches in the air" with no specific explanation.
I really appreciate if... (6 Replies)
Discussion started by: aix_xia
6 Replies
7. Ubuntu
Boot process hangs after reaching the following line:
Adding 5853176k swap on /dev/mapper/mch-swap_1. Priority:-1 extents:1 across:5853176kUsing knoppix 6.2 as LiveCD, and mounting the partitions, I got the following:
# /etc/fstab: static file system information.
#
# Use 'blkid -o value -s... (0 Replies)
Discussion started by: fzaker
0 Replies
8. Solaris
Can anyone tell me the command to check all the hardware information in Ok boot Prompt. Like the hard disk space memory size ..... (3 Replies)
Discussion started by: newbi8321
3 Replies
9. Solaris
Hi Guys,
I have a SunBlade 1500 which I use to practice at home. Suddenly when I power on the server it just displays the solaris banner and Boot device: disk File and args: Then it stops and says " rebooting with command: boot"
It doesn't boot to the kernel. Is there anyway I can possibly... (5 Replies)
Discussion started by: cjashu
5 Replies
10. Solaris
Power server up runs through diagnostics.
Goes to the boot section and then the bit where the cursor is spinning and thats it. Hangs completely.
Any ideas? (10 Replies)
Discussion started by: psychocandy
10 Replies
LEARN ABOUT MOJAVE
systemd-ask-password-console.service
SYSTEMD-ASK-PASSWORD-CONSOLE.SERVICE(8) systemd-ask-password-console.service SYSTEMD-ASK-PASSWORD-CONSOLE.SERVICE(8) NAME
systemd-ask-password-console.service, systemd-ask-password-console.path, systemd-ask-password-wall.service, systemd-ask-password-wall.path - Query the user for system passwords on the console and via wall SYNOPSIS
systemd-ask-password-console.service systemd-ask-password-console.path systemd-ask-password-wall.service systemd-ask-password-wall.path DESCRIPTION
systemd-ask-password-console.service is a system service that queries the user for system passwords (such as hard disk encryption keys and SSL certificate passphrases) on the console. It is intended to be used during boot to ensure proper handling of passwords necessary for boot. systemd-ask-password-wall.service is a system service that informs all logged in users for system passwords via wall(1). It is intended to be used after boot to ensure that users are properly notified. See the developer documentation[1] for more information about the system password logic. Note that these services invoke systemd-tty-ask-password-agent(1) with either the --watch --console or --watch --wall command line parameters. SEE ALSO
systemd(1), systemd-tty-ask-password-agent(1), wall(1) NOTES
1. developer documentation https://www.freedesktop.org/wiki/Software/systemd/PasswordAgents systemd 237 SYSTEMD-ASK-PASSWORD-CONSOLE.SERVICE(8)