Thanks for the answer! It turns out I had actually done it correctly before, I must have fat fingered something. The numbers at the end are designations of disks (channel, and then disk divided by a whitespace character - for example, 0,4 and 0,5 is "0 4 0 5"). I also hadn't set a build method.
The final string I used (as an example for other people who may have issues):
Can anyone out there help me out? I'm trying to install a scsi tape back up on a sys running sco openserver 5.0.4. When I go through the steps for mkdev tape it seems like it works, but when I reboot I still don't see the tape. Also when it boots up I get a scsi bios not installed error. I've... (1 Reply)
Trying to install Sco OSR 6.0 on Dell Optiplex with SERIAL ATA ADADPTEC 1210SA controller.
Sco says its sipported by the AACRAID driver but on installation its says that it doesnt recognise the partitions
In the middle of re-formatting at the moment - just wondered if anyone had anu... (0 Replies)
I am installing SCO UNIX 5.0.6 in X3400, every thing are install except Adaptec 29320ALP Card (Attached DAT Drive) because their driver are available in btld formate Fllopy DISk and SCO Unix 5.0.6 not support USB Floppy, Can anybody inform us any other method to installed the Adaptec Ultra 120... (3 Replies)
Hey there,
I am starting a Computer Science Foundation year at the end of this month and am trying to get a little bit ahead of the game. I have always wanted to learn Unix and am currently struggling with creating a boot disc to run Solaris (I have chosen to study this) from as opposed to... (0 Replies)
I am new to Sun.
I brought Sun Fire 280R to practice UNIX. What are the requirements for the monitor/CRT? Will it burn out old non-Sun CRTs? Does it need LCD monitor?
Thanks. (3 Replies)