Check your duplex setting :
The output has the following meaning:
link_up - 0 down, 1 up
link_speed - speed in Mbit/s
link_duplex - 1 half duplex, 2 full duplex, 0 down
Following will set interface to 100-FD, Forced config. Enable autoneg if you wish to use it.
You have to make relevant changed on switch side also
I am experiencing a problem where under a dial condition I am experiencing packet loss, which is failrly normal, but the response to the packet loss is taking bewteen 6 and 10 seconds. Could someone please advise what the industry standard is on the response time under a packet loss senario. (1 Reply)
I have 4 network ports on our T5240 sun server.
all but 1 gives packet losses (nxge1)
nxge0 gives on average 50% packet loss, very bad.
nxge2 gives on average 1-2% packet loss.
nxge3 gives on average 20% packet loss.
Is there a tool or something to help me find the problem? (11 Replies)
Hello,
I'm writing to you because I encountered the following problem. My program displayes all network interfaces that are available in the system, but I would like to add a functionality in which a user can enter a destination address IP (ex. the IP address of the Google search engine) and will... (1 Reply)
Dear all,
I am a newbie in solaris and I need your advice.
I have a Solaris version 5.9 installed on Sunfire V240.
I am able to ssh the machine from putty remotely.
My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)
Hi all
I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface?
If you have any ideas, please tell me then. Thank you (2 Replies)
This is my situation
DOS pc serial cable (sl0) Linux Pc eth1
192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router)
I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface.
... (3 Replies)
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
RHEL 7.0, IPV6
Scenario:
I have routed specific network using network scripts.
1. "ip -6 route show" shows that route has been added. ( with metric 1024)
2. Ping of the specific IP through that route is successful.
3. Now after few days, for some reason, we see that cache route appears for... (3 Replies)