NETDEVICE(7)						     Linux Programmer's Manual						      NETDEVICE(7)

NAME

       netdevice - Low level access to Linux network devices.

SYNOPSIS

       #include <sys/ioctl.h>
       #include <net/if.h>

DESCRIPTION

       This man page describes the sockets interface which is used to configure network devices.

       Linux supports some standard ioctls to configure network devices. They can be used on any socket's file descriptor regardless of the family
       or type.  They pass an ifreq structure:

       struct ifreq {
	   char    ifr_name[IFNAMSIZ];/* Interface name */
	   union {
		   struct sockaddrifr_addr;
		   struct sockaddrifr_dstaddr;
		   struct sockaddrifr_broadaddr;
		   struct sockaddrifr_netmask;
		   struct sockaddrifr_hwaddr;
		   short   ifr_flags;
		   int	   ifr_ifindex;
		   int	   ifr_metric;
		   int	   ifr_mtu;
		   struct ifmapifr_map;
		   char    ifr_slave[IFNAMSIZ];
		   char    ifr_newname[IFNAMSIZ];
		   char *  ifr_data;
	   };
       };

       struct ifconf {
	   int ifc_len;    /* size of buffer */
	   union {
		   char *  ifc_buf; /* buffer address */
		   struct ifreq *ifc_req; /* array of structures */
	   };
       };

       Normally, the user specifies which device to affect by setting ifr_name to the name of the interface. All other members	of  the  structure
       may share memory.

IOCTLS

       If  an  ioctl  is marked as privileged then using it requires an effective user id of 0 or the CAP_NET_ADMIN capability. If this is not the
       case EPERM will be returned.

       SIOCGIFNAME
	      Given the ifr_ifindex, return the name of the interface in ifr_name.  This is the only ioctl which returns its result in ifr_name.

       SIOCGIFINDEX
	      Retrieve the interface index of the interface into ifr_ifindex.

       SIOCGIFFLAGS, SIOCSIFFLAGS
	      Get or set the active flag word of the device.  ifr_flags contains a bitmask of the following values:

					 Device flags
	      IFF_UP		Interface is running.
	      IFF_BROADCAST	Valid broadcast address set.
	      IFF_DEBUG 	Internal debugging flag.
	      IFF_LOOPBACK	Interface is a loopback interface.
	      IFF_POINTOPOINT	Interface is a point-to-point link.
	      IFF_RUNNING	Resources allocated.
	      IFF_NOARP 	No arp protocol, L2 destination address not set.
	      IFF_PROMISC	Interface is in promiscuous mode.
	      IFF_NOTRAILERS	Avoid use of trailers.
	      IFF_ALLMULTI	Receive all multicast packets.
	      IFF_MASTER	Master of a load balancing bundle.
	      IFF_SLAVE 	Slave of a load balancing bundle.
	      IFF_MULTICAST	Supports multicast
	      IFF_PORTSEL	Is able to select media type via ifmap.
	      IFF_AUTOMEDIA	Auto media selection active.
	      IFF_DYNAMIC	The addresses are lost when  the  interface  goes
				down.

	      Setting the active flag word is a privileged operation, but any process may read it.

       SIOCGIFMETRIC, SIOCSIFMETRIC
	      Get  or set the metric of the device using ifr_metric.  This is currently not implemented; it sets ifr_metric to 0 if you attempt to
	      read it and returns EOPNOTSUPP if you attempt to set it.

       SIOCGIFMTU, SIOCSIFMTU
	      Get or set the MTU (Maximum Transfer Unit) of a device using ifr_mtu.  Setting the MTU is a privileged operation. Setting the MTU to
	      too small values may cause kernel crashes.

       SIOCGIFHWADDR, SIOCSIFHWADDR
	      Get  or  set  the hardware address of a device using ifr_hwaddr.	The hardware address is specified in a struct sockaddr.  sa_family
	      contains the ARPHRD_* device type, sa_data the L2 hardware address starting from byte 0.	Setting the hardware address is  a  privi-
	      leged operation.

       SIOCSIFHWBROADCAST
	      Set the hardware broadcast address of a device from ifr_hwaddr.  This is a privileged operation.

       SIOCGIFMAP, SIOCSIFMAP
	      Get or set the interface's hardware parameters using ifr_map.  Setting the parameters is a privileged operation.

	      struct ifmap
	      {
		  unsigned long   mem_start;
		  unsigned long   mem_end;
		  unsigned short  base_addr;
		  unsigned char   irq;
		  unsigned char   dma;
		  unsigned char   port;
	      };

	      The interpretation of the ifmap structure depends on the device driver and the architecture.

       SIOCADDMULTI, SIOCDELMULTI
	      Add an address to or delete an address from the device's link layer multicast filters using ifr_hwaddr.  These are privileged opera-
	      tions.  See also packet(7) for an alternative.

       SIOCGIFTXQLEN, SIOCSIFTXQLEN
	      Get or set the transmit queue length of a device using ifr_qlen.	Setting the transmit queue length is a privileged operation.

       SIOCSIFNAME
	      Changes the name of the interface specified in ifr_name to ifr_newname.  This is a privileged operation. It is only allowed when the
	      interface is not up.

       SIOCGIFCONF
	      Return a list of interface (transport layer) addresses. This currently means only addresses of the AF_INET (IPv4) family for compat-
	      ibility.	The user passes a ifconf structure as argument to the ioctl. It contains a pointer to an  array  of  ifreq  structures	in
	      ifc_req  and  its length in bytes in ifc_len.  The kernel fills the ifreqs with all current L3 interface addresses that are running:
	      ifr_name contains the interface name (eth0:1 etc.), ifr_addr the address.  The kernel returns with the actual length in ifc_len.	If
	      ifc_len  is  equal  to  the  original length the buffer probably has overflowed and you should retry with a bigger buffer to get all
	      addresses.  When no error occurs the ioctl returns 0; otherwise -1. Overflow is no error.

       Most protocols support their own ioctls to configure protocol specific interface options. See the protocol man  pages  for  a  description.
       For configuring IP addresses see ip(7).

       In addition some devices support private ioctls. These are not described here.

NOTES

       Strictly seen, SIOCGIFCONF is IP specific and belongs in ip(7).

       The names of interfaces with no addresses or that don't have the IFF_RUNNING flag set can be found via /proc/net/dev.

       Local IPv6 IP addresses can be found via /proc/net or via rtnetlink(7).

BUGS

       glibc 2.1 is missing the ifr_newname macro in net/if.h. Add the following to your program as workaround:

	      #ifndef ifr_newname
	      #define ifr_newname     ifr_ifru.ifru_slave
	      #endif

SEE ALSO

       ip(7), proc(7), rtnetlink(7)

Linux Man Page							    1999-05-02							      NETDEVICE(7)