USB-USB cable between linux and windows computers Post: 302449816

6 More Discussions You Might Find Interesting

1. Hardware

How to install a driver of my USB-A to Serial Cable

Hi Gurus of Unix Recently I install a OpenSolaris in My HP 530 In this moment want to install a USB-A to Serial Cable. Any guru can send a Link where I can use how reference. I want to configure a Router and my PC don't have any serial Port. My LapTOP only has USB ports. In this case I buy a...

2. Red Hat

Installing LINUX KS from USB

:confused:Hello All, We are trying to install RHEL6 via USB using KICKSTART installation. We had following configuration: Below is the entry of isolinux.cfg file : menu label ^Kickstart Installation:via USB kernel vmlinuz append initrd=initrd.img ks=cdrom:/ks.cfg Below is the entry...

3. Ubuntu

[SOLVED] Dual boot Windows 7 and Ubuntu on USB

I am trying to dual boot on an external USB 500GB drive using my laptop.I have Windows 7 installed and booting on 1st partition 230GB now as active primary, 2nd partition is 100GB as primary, and 3rd partition is 135GB as primary. I was intending on installing Ubuntu onto the 2nd partition. I read...

4. Filesystems, Disks and Memory

Can I create Windows repair software in USB rather than CD?

My CD drive isn't working. So, is there any way to create windows recovery/repair software in flash drive/usb. This is the s/w which we use if system fails to boot.

5. Boot Loaders

Can I test windows 7 repair usb even if windows is fine?

I successfully created a bootable windows 7 repair usb. Please clarify me: I rebooted my system via USB. windows repair window appeared. There were 5 options. I opted 'windows memory diagnostic' and it worked fine. There was an option named 'start up repair'. This option can be used if windows...

6. HP-UX

Configure X windows with both keyboard and USB barcode reader

Greetings. Seeking guidance on adding a USB barcode reader (BCR) to an HP c3750 workstation with HP-UX 11.11 which is essentially configuring X windows to accept input from both a primary keyboard and a secondary keyboard that happens to be the BCR. Historically, I have successfully added a BCR...

LEARN ABOUT FREEBSD

usb_template

USB_TEMPLATE(4) 					   BSD Kernel Interfaces Manual 					   USB_TEMPLATE(4)

NAME

     usb_template -- USB templates

SYNOPSIS

     To compile this module into the kernel, place the following line in your kernel configuration file:

	   device usb_template

     To load the module at boot time, place the following line in loader.conf(5):

	   usb_template_load="YES"

DESCRIPTION

     The usb_template module implements various USB templates that are needed when programming an USB device side driver.  A USB template consists
     of an USB device descriptor, one or more USB configuration descriptors, one or more USB interface descriptors, one or more USB endpoint
     descriptors, USB strings and additional USB descriptors.  The USB template module currently has templates for USB Mass Storage, USB CDC Eth-
     ernet and Message Transfer Protocol.  USB templates are currently selected using the "hw.usb.template" sysctl.  The "hw.usb.template" value
     can be changed at any time, but will not have any effect until the USB device has been re-enumerated.

SEE ALSO

     usb(4)

STANDARDS

     The usb_template module complies to the USB 1.0, 2.0 and 3.0 standard.

HISTORY

     The usb_template module was written by Hans Petter Selasky <hselasky@FreeBSD.org>.

BSD
								  March 18, 2014							       BSD