puts(n) 						       Tcl Built-In Commands							   puts(n)

__________________________________________________________________________________________________________________________________________________

NAME

       puts - Write to a channel

SYNOPSIS

       puts ?-nonewline? ?channelId? string
_________________________________________________________________

DESCRIPTION

       Writes  the  characters	given by string to the channel given by channelId.  ChannelId must be a channel identifier such as returned from a
       previous invocation of open or socket. It must have been opened for output. If no channelId is specified then it defaults to  stdout.  Puts
       normally outputs a newline character after string, but this feature may be suppressed by specifying the -nonewline switch.

       Newline	characters  in	the output are translated by puts to platform-specific end-of-line sequences according to the current value of the
       -translation option for the channel (for example, on PCs newlines are normally replaced with carriage-return-linefeed sequences;  on Macin-
       toshes newlines are normally replaced with carriage-returns).  See the fconfigure manual entry for a discussion on ways in which fconfigure
       will alter output.

       Tcl buffers output internally, so characters written with puts may not appear immediately on the output file or device;	Tcl will  normally
       delay output until the buffer is full or the channel is closed.	You can force output to appear immediately with the flush command.

       When the output buffer fills up, the puts command will normally block until all the buffered data has been accepted for output by the oper-
       ating system.  If channelId is in nonblocking mode then the puts command will not block even if the  operating  system  cannot  accept  the
       data.   Instead,  Tcl  continues to buffer the data and writes it in the background as fast as the underlying file or device can accept it.
       The application must use the Tcl event loop for nonblocking output to work;  otherwise Tcl never finds out that the file or device is ready
       for more output data.  It is possible for an arbitrarily large amount of data to be buffered for a channel in nonblocking mode, which could
       consume a large amount of memory.  To avoid wasting memory, nonblocking I/O should normally be used in an  event-driven	fashion  with  the
       fileevent  command  (don't  invoke  puts  unless you have recently been notified via a file event that the channel is ready for more output
       data).

SEE ALSO

       file(n), fileevent(n)

KEYWORDS

       channel, newline, output, write

Tcl									7.5								   puts(n)