Can I run Perkin Elmer software on SCO ? Post: 302371431

5 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

How can i set up Software disk mirroring(Raid1) in SCO 5.0.5 with two SCSI harddisk ?

thank u very much,

2. SCO

Software router on SCO Unixware 2.X

Hi, I am trying to setup an old SCO Unix 2.x box to act as a router. I have got 2 network cards in the box. As far as I know, I need to setup "ip forwarding" and "routes". Can anyone tell me how to setup "ip forwarding" on SCO Unixware 2.X?

3. UNIX for Advanced & Expert Users

Netscape - What version will run on SCO Unix v3.2 2 Release 5

This question has been resolved.

4. SCO

I need a box to run SCO 3.2 5.0.5 i386 with...

need it to be able to run Seagate STT8000A tape drive. Any suggestions where to go.

5. SCO

Recommendation for hardware to run SCO OSR 5.0.7 natively

Looking for a modern server to run SCO OSR 5.0.7 without VM (native), h/w must have manufacturers warranty. Requirements would be to accommodate light loads of up to 15 users, app does not take more than 30 - 40 MB of RAM and data stored takes up to 15 - 20 GB, no internet connections...

LEARN ABOUT LINUX

mkfs.bfs

MKFS.BFS(8)						Linux System Administrator's Manual					       MKFS.BFS(8)

NAME

       mkfs.bfs - make an SCO bfs filesystem

SYNOPSIS

       mkfs.bfs [-N nr-of-inodes] [-V volume-name] [-F fsname] device [size-in-blocks]

DESCRIPTION

       mkfs.bfs creates an SCO bfs file-system on a block device (usually a disk partition or a file accessed via the loop device).

       The  size-in-blocks  parameter  is  the	desired size of the file system, in blocks.  If nothing is specified, the entire partition will be
       used.

OPTIONS

       -N     Specify the desired number of inodes (at most 512).  If nothing is specified some default number	in  the  range	48-512	is  picked
	      depending on the size of the partition.

       -V volume-label
	      Specify the volume label. I have no idea if/where this is used.

       -F fsname
	      Specify the fsname. I have no idea if/where this is used.

       -v     Be verbose.

EXIT CODES

       The exit code returned by mkfs.bfs is 0 when all went well, and 1 when something went wrong.

SEE ALSO

       mkfs(8).

AVAILABILITY

       The mkfs.bfs command is part of the util-linux package and is available from ftp://ftp.kernel.org/pub/linux/utils/util-linux/.

Util-linux 2.9x 						   12 Sept 1999 						       MKFS.BFS(8)