hi incredible,
thanks for the response.
This is connected via switch.
Please give me 12 more hours as I am not near the systems. Thanks a lot.
one more important thing is that, if i remove the following entry from /etc/hosts of jumpstart server:
then the sparc machine will boot from the server, but it ignores the sysidcfg files and works like a normal installation, asking interactive questions starting from Choose Language, etc.
But if i put the above entry back again, the above problem arises. Something related to the ip resolution...(localhost), that is what the link i provided also says, but i cant understand that...!!
---------- Post updated 10-12-09 at 09:47 PM ---------- Previous update was 10-11-09 at 10:03 PM ----------
Following is the content of /etc/bootpararms:
---------- Post updated 10-13-09 at 05:14 PM ---------- Previous update was 10-12-09 at 09:47 PM ----------
Hi,
Which sites have general information on JumpStart for Solaris 8?
I would like to know more about boot server, installation server, and configuration server.... and all other good things about JumpStart....Thanks..:p
Doo... (2 Replies)
Hello all,
I configured a jumpstart server ( the server is in the same subnet as the client) and gave boot net - install in the client.
The client boots up shows the banner and then displays error:
cant read disk label
cant open disk label package
and then goes to OK prompt.
What... (1 Reply)
Hi Peeps,
Created a jumpstart server for an unattened install and it works, but got 2 bugs in the config which I would like to work out:
when you boot net install
It still asks you to select a language and locale, after you do this it kicks of an unattended install.
So my question is,... (5 Replies)
I'm trying to jumpstart my remote server. My /etc/hosts and /etc/ethers files have the correct data. Keep getting the following message at the ok prompt
after running a boot net - install
Link hasn't comeup yet
Ran a test-net and got the following message.
Link is -- down
When... (7 Replies)
Hi all,
I'm having an issue with jumpstart that I haven't seen before. After booting the server and selecting F12 to boot it from the network it finds the jumpstart profile that has been set up for it and proceeds with the build until I get the following error:
SunOS Release 5.10 Version... (4 Replies)
hi friends,
i dont know how to install jumpstart . i have solaris cds( 5 nos.). i tried to install jumpstart but there is no setup_install_server file. What i want to do for installing jumpstart server
please help me
thanks to all (8 Replies)
I'm trying to use a V210 (sun4u) configured as a jumpstart server to flash install a number of T5220's (sunv4).
The Facts:
V210 - Solaris 10 (September 2010 Release / not patched)
T5220's - Archive's created using prior (unknown) version of solaris 10.
Flar -i <archive name> shows the... (6 Replies)