I have an RHEL 5 server with 2 Broadcom on-board NICs and 2 quad-port Intel NICs. After I installed the OS, the Intel NICs became eth0-7, and the onboards are eth8 and eth9. I really need the onboard NICs to be eth0 and eth1 (I have plans to later remove the quad-ports and replace them with 10gE cards but that's another story). What's the right way to renumber the existing eth devices? I have the following entries in modprobe.conf:
Should I just change the names in there and also modify the ifcfg-* files? Or is there more to this? How do I make sure that after I reboot, the names will not change back?
All,
I have a need to software change the MAC address of a NIC in a Sparc Ultra 10 - I believe there is a command that allows to do this at boot up?
Is it a missing (to me) part of ifconfig ?
If so, what is the syntax?
All replies gratefully received !
Thanks
Andrew (3 Replies)
I am trying to locate a non IBM PCI Ethernet card that will work with the Model B50 RISC box. Alternatively, I need to find AIX drivers for standard PCI Ethernet NIC's ?. (0 Replies)
Hi,
I would like to know how to change the speed of ethernet card in linux? as it is showing auto-neg using mii-tool -v eth0
and my requirement is 100mbps full duplex.
Regards,
Manoj (3 Replies)
Hi,
Does anyone know how can I determine the maximum capable speed on a network interface card for different OS like HP, Sun, AIX and Linux.
I am aware of the tool "ethtool" which can be used for Linux. Are there any handly commands or /proc files where I can get this info depending on the OS.... (3 Replies)
hi guys,
is there any way to change the nic link_speed in Solaris 10? now my box is running degraded performance of the link speed as the switch is upgraded from 100m to 1000m.
dladm show-dev
e1000g0 link: up speed: 100 Mbps duplex: full
e1000g1 link: up ... (10 Replies)
Hi,
is there any method to check the interface collisions on ethernet NIC in AIX. I know that in Solaris it's netstat -i but I've written that in AIX it doesn't show this.
Thanks®ards,
p (1 Reply)
I have a RAC setup that was configured before I started at my new company. I would like to reconfigure the network devices and change the names. How complex is this regarding the Oracle RAC environment? Does the Oracle RAC rely on the device name or is it only relying on the IP information?
... (1 Reply)
Dear all,
I have a remote CentOS7 server that has two network cards. Each card has four ports and port one of card one was defined with the IP address assigned to the server. So far, so good and it's been working for over a year. We have now got cables sorted out so there are four paths... (4 Replies)