Sponsored Content
Full Discussion: Solaris in a SAN BOOT
Operating Systems Solaris Solaris in a SAN BOOT Post 302337936 by Sun Fire on Sunday 26th of July 2009 10:55:36 AM
Old 07-26-2009
I'm not quite sure that booting Solaris from NetApp LUNs is supported by SUN.
 

9 More Discussions You Might Find Interesting

1. HP-UX

Need Help for configuring Boot from San

Hi all, I am trying to configure my HPUX host 11.31 IA64 to boot from a LUN for EMC clariion CX3-80 (Flaire PNR 26). I am following the below mentioned steps.. vi /tmp/idf 3 EFI 500MB HPUX 100% HPSP 400MB idisk -f /tmp/idf -w /dev/rdisk/diskxxx insf -e pvcreate -B... (0 Replies)
Discussion started by: barun agarwal
0 Replies

2. Red Hat

rhel-5.2-64bit, boot from SAN

hi all, i have qle 2460 hba card in my server. and i have a lun from promise array from raid 0. I want to boot my OS (rhel5.2-64 bit) lun on a dell t300 server. can some one help me on this please asap.. (0 Replies)
Discussion started by: navadeep
0 Replies

3. UNIX for Advanced & Expert Users

Can AIX 5.3 - 6 Boot From HP EVA 6000 SAN

Hi There, Has anyone had any luck with or know how to get AIX 5+ to boot from a HP EVA 6000 SAN? The servers used here will be P Class Blades My initial searches on this so far did not bring results so I am guessing this may not be possible on HP SAN's but please let me know if I am... (0 Replies)
Discussion started by: fazzasx
0 Replies

4. AIX

p595 LPAR no longer sees SAN boot disk

Hello, we have a wierd and urgent problem, with a few of our p595 LPARs running AIX 5.3. The LPARs ran AIX 5.3 TL 7 and booted off EMC SAN disks, using EMC Powerpath. Every boot we run "pprootdev on" and "pprootdev fix". We can issue "bosboot -a" and we can reboot the machines. Now, on two... (2 Replies)
Discussion started by: rwesterik
2 Replies

5. Solaris

SAN boot solaris 10

I have a solaris 10 box which does not have internal disks it has just a single dual port HBA card. Storage team has assigned 2 LUNs to the system and i can see it from the probe-scsi-all /pci@3,700000/SUNW,emlxs@0,1 Device PortID 10100 WWPN 5006016941e0a08d LUN 0 Disk DGC ... (0 Replies)
Discussion started by: fugitive
0 Replies

6. Solaris

Identify Boot from SAN

How to identify the server is BOOT FROM SAN. Also how one can find from which device it is booted? Thanks Rahul Double post, continued here (0 Replies)
Discussion started by: rahul.kurumkar
0 Replies

7. Red Hat

Identify Boot from SAN

Hi, I have many servers all of these are boot from SAN. Can anybody let me know that how to identify the server is Boot fron SAN and from which device? Thanks Rahul (1 Reply)
Discussion started by: rahul.kurumkar
1 Replies

8. AIX

AIX san boot from EMC2 & NPIV

Hi all , we're implementing a new NPIV infrastructure with AIX san boot on EMC2 VMAX 5876 , for economic reason , they don't wont to install Powerpath multipath sw , but only ODM drivers from EMC2 , this behavior is supported and can work?! in the past we implemented NPIV on DS8000 family... (2 Replies)
Discussion started by: BabylonRocker76
2 Replies

9. Red Hat

Volume group not activated at boot after SAN migration

I have an IBM blade running RHEL 5.4 server, connected to two Hitachi SANs using common fibre cards & Brocade switches. It has two volume groups made from old SAN LUNs. The old SAN needs to be retired so we allocated LUNs from the new SAN, discovered the LUNs as multipath disks (4 paths) and grew... (4 Replies)
Discussion started by: rbatte1
4 Replies
ieee1394(7D)															      ieee1394(7D)

NAME
ieee1394, firewire - Solaris IEEE-1394 Architecture IEEE-1394 provides a means for interconnecting devices in computer and home entertainment systems. (The IEEE-1394 architecture is also known as Firewire, an Apple Computer trademark, and i.Link, a Sony trademark). The most common IEEE-1394 devices are digital camcorders, mass-storage devices and cameras (including webcam-type devices). For more information on USB, refer to the 1394 Trade Association website at http://www.1394ta.org. The Solaris IEEE-1394 architecture supports up to 63 hot-pluggable IEEE-1394 devices per IEEE-1394 bus. The maximum data transfer rate is 400 Mbits, depending on the capabilities of the attached device. The Solaris IEEE-1394 architecture supports devices implementing a number of different specifications. The basic behavior of the IEEE-1394 bus is described in the IEEE 1394-1995 and IEEE 1394a-2000 specifications. IEEE-1394 host controllers implementing the 1394 Open Host Controller Interface specification are supported. Camcorders implementing the IEC 61883 and 1394 Trade Association AV/C specifications are supported. Mass-storage devices implementing the ANSI SBP-2 specification are supported. Digital cameras implementing the 1394 Trade Association 1394-based Digital Camera (IIDC) specification are supported. FILES
Listed below are drivers and modules which either utilize or are utilized by the Solaris IEEE-1394 architecture. Drivers in /kernel/drv are 32 bit drivers (only). Drivers in /kernel/drv/sparcv9 or /kernel/drv/amd64 are 64 bit drivers. +-----------------------------------+-------------------------------+ | SUPPORT MODULE(S) | FUNCTION | +-----------------------------------+-------------------------------+ |/kernel/misc/[sparcv9|amd64/]s1394 | IEEE-1394 framework | +-----------------------------------+-------------------------------+ |/kernel/misc/[sparcv9|amd64/]sbp2 | Serial Bus Protocol-2 (SBP-2) | +-----------------------------------+-------------------------------+ +-----------------------------------+-----------------------------+ | TARGET DRIVER | DEVICE CLASS | +-----------------------------------+-----------------------------+ |/kernel/drv/[sparcv9|amd64/]s1394 | IEEE-1394 framework | +-----------------------------------+-----------------------------+ |/ker- | mass storage class | |nel/drv/[sparcv9|amd64/]scsa1394 | | +-----------------------------------+-----------------------------+ |/kernel/drv/[sparcv9|amd64/]av1394 | camcorder (AV/C) class | +-----------------------------------+-----------------------------+ |/ker- | digital camera (IIDC) class | |nel/drv/[sparcv9|amd64/]dcam1394 | | +-----------------------------------+-----------------------------+ +------------------------------------+----------------------------+ |HOST CONTROLLER INTERFACE DRIVER(S) | DEVICE | +------------------------------------+----------------------------+ |/kernel/drv/[sparcv9|amd64/]hci1394 | Open HCI | +------------------------------------+----------------------------+ See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Architecture |PCI-based systems | +-----------------------------+-----------------------------+ |Availability |SUNW1394, SUNW1394h, SUN- | | |Wav1394, SUNWscsa1394, SUN- | | |Wsbp2, SUNWfwdc, SUNWfwdcu | +-----------------------------+-----------------------------+ attributes(5), av1394(7D), dcam1394(7D), hci1394(7D), scsa1394(7D) http://www.sun.com/io IEEE 1394a Specification - 1394 Trade Association, 2000 IEEE 1394 Specification - 1394 Trade Association, 1995 NOTES
Booting from IEEE-1394 mass-storage devices is not supported, but may be possible if supported by the BIOS of the computer system. 30 August 2005 ieee1394(7D)
All times are GMT -4. The time now is 12:37 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy