Hello,
Under ksh I have to run a script on one of the nodes of a Solaris 8 cluster which at some time must execute a command on the alternate node:
# rsh <name> "command"
I have to implement this script on all the clusters of my company (a lot of...).
Fortunately, the names of the two nodes... (11 Replies)
How can we add a shared zfs dataset between 2 zones on a same host. I have sun cluster 3.2 installed in a server which has 2 zones. I want to share a zfs data set between these 2 zones how can we do that ? (7 Replies)
Hi,
Is it possible to have a Solaris cluster of 2 nodes at SITE-A using SVM and creating metaset using say 2 LUNs (on SAN). Then replicating these 2 LUNs to remote site SITE-B via storage based replication and then using these LUNs by importing them as a metaset on a server at SITE-B which is... (0 Replies)
Hey Admins,
I am running sun cluster 3.2 x86 on Vmware. I m facing an issue from 2 days..
One main node is continuously rebooting..... not sure... whats woring...
I just had change heartbeat timeout values on 1 this node... Now both node are just rebooting itself..seems panic..
Any... (1 Reply)
Hello experts -
I am planning to install a Sun cluster 4.0 zone cluster fail-over. few basic doubts.
(1) Where should i install the cluster s/w binaries ?. ( global zone or the container zone where i am planning to install the zone fail-over)
(2) Or should i perform the installation on... (0 Replies)
Setting up HACMP 6.1 on a two node cluster. The other node works fine and can start properly on STABLE state (VGs varied, FS mounted, Service IP aliased). However, the other node is always stuck on ST_JOINING state. Its taking forever and you can't stop the cluster as well or recover from script... (2 Replies)
Hi All,
I was asked to Switch the service from failover to active node as we need to reboot active node for regular maintenance. Unfortunately our senior admin left the organization. It would be helpful if some one answer this query. Detailed info with steps will be appreciated.
Here are... (1 Reply)
Discussion started by: vamshigvk475
1 Replies
LEARN ABOUT DEBIAN
4s-backend-setup
4S-BACKEND_SETUP(1J) 4store 4S-BACKEND_SETUP(1J)NAME
4s-backend-setup -- Create a new 4store KB
SYNOPSIS
4s-backend-setup kbname [--node node-number] [--cluster cluster-size] [--segments segment-count] kb-name
--node Number of this node in the cluster, values range from 0 to cluster-size - 1. The default is 0.
--cluster
The number of nodes in the cluster. The default is 1.
--segments
The number of segments in the cluster. The default is 2. We recommend one for each CPU core in the cluster as a good
starting point. Higher numbers tend to consume more resources, but may result in increased performance.
NOTES
Once crated with 4s-backend-setup KBs should be started with 4s-backend(1)SEE ALSO 4s-query(1), 4s-size(1), 4s-httpd(1), 4s-backend(1), 4s-delete-model(1)EXAMPLES
$ 4s-backend-setup --node 0 --cluster 1 --segments 4 demo
Creates the indexes for a single-machine KB with four segments, named "demo".
4store May 31, 2019 4store