|
|
Sponsored Content
Operating Systems
OS X (Apple)
Use a Serial Console with Mac OS X Leopard
Post 302328081 by dalek on Tuesday 23rd of June 2009 09:35:10 AM
06-23-2009
|
|
2 More Discussions You Might Find Interesting
1. Shell Programming and Scripting
Hi all
I had a nice simple backup script on my mac running Tiger. I used an Automator 'Run Shell Script' command that loaded psync and backed up one directory on an external drive to a directory on another external drive. This was the command
/usr/local/bin/runpsync 0 0 0... (1 Reply)
Discussion started by: Billy T
1 Replies
2. OS X (Apple)
I want to install MAC X 5.x on my T60 Lenova laptop. I have the Original Mac X 5.0 installation media. I tried to install it on a blank hard disk in my laptop but it doesn't work. On the internet I found sites that offer torrent downloads but I can't use torrent downloads on my laptop. (Corp... (1 Reply)
Discussion started by: mndavies
1 Replies
LEARN ABOUT ULTRIX
mdc
mdc(4) Kernel Interfaces Manual mdc(4) Name mdc - DS5100 serial line driver Syntax device mdc0 at ibus? vector mdcintr device mdc1 at ibus? vector mdcintr device mdc2 at ibus? vector mdcintr Description A DS5100 base system (mdc0) provides four asynchronous ports. An optional asynchronous card (mdc1 and mdc2 ) can be added to supply eight additional ports. The mdc ports are used as follows: Port Usage Connector 0 Console port 6-pin MMJ on CPU board 1 Local terminal 6-pin MMJ on CPU board 2 Full modem control port 25-pin D-Sub on CPU board 3 Local terminal 6-pin MMJ on CPU board An optional asynchronous board provides an additional eight lines: 4 Local terminal 6-pin MMJ 5 Local terminal 6-pin MMJ 6 Full modem control port 25-pin D-Sub 7 Local terminal 6-pin MMJ 8 Local terminal 6-pin MMJ 9 Local terminal 6-pin MMJ 10 Local terminal 6-pin MMJ 11 Local terminal 6-pin MMJ The console baud rate is set to 9600 baud by default. You can change this by setting the baud environment variable from console prompt. Each communication port from the serial line controller behaves as described in the reference page and can be set to run at any of 16 speeds. For the encoding, see You can establish the state of port 2 (port 6) by specifying either modem or nomodem as part of the file entry. Restrictions The speed default is to 9600 baud on the console port. The console device must be set for 8-bit character length with one stop bit and no parity. The driver enforces these restrictions; that is, changing speeds with the command may not always work on console ports. Files Console terminal Full modem control or local terminal See Also console(4), devio(4), tty(4), ttys(5), MAKEDEV(8) RISC mdc(4)