DROBOM(8)							      droboa								 DROBOM(8)

NAME

       drobom - CLI for managing drobo units

SYNOPSIS

       drobom [ options ] <command> [ arguments... ]

DESCRIPTION

   options is one of:
       -c, --command
	      the command to execute.

       -d, --device
	      the device to operate on (default searches all devices and picks first one found.)

       -h, --help
	      print a usage message

       -v, --verbose
	      verbosity,  a  bit-field to trigger increased output as needed, mostly for debugging.  1 - General, 2 - Hardware Dialog, 4 - Initia-
	      tion, 8 - DMP layer, 16- Detection 64 will print everything... (default: 0, as terse as possible.)  128 enables simulation mode (for
	      testing when no Drobo is available. Dangerous!)

       -V, --version
	      print the version id.

   command is one of:
       blink  identify the drobo by making the lights blink

       diag   dump diagnostics file into /tmp directory

       diagprint <diagdumpfile>
	      print diagnostics file to standard output

	      <diagdumpfile> the diagnostic dump file to print.

       fwcheck query drobo.com for updates to firmware for the given Drobo
	      fwload  load a specific firmware for the given Drobo. Arguments:

	      <fwimage> the firmware file to load.

       fwupgrade
	      upgrade the firmware to the latest and greatest, recommended by DRI

       help   print this text

       info  <toprint>
	      print  information  on  a  Drobo.  The  <toprint> argument is a comma separated list of the values below (default is to print all of
	      them): config, capacity, protocol, settings, slots, firmware, status, options, luns

       list   show device files for all Drobos found.

       name  <newname>
	      Set the name of the Drobo to the given value ( only firmware > 1.3.0 supports this command )

       settime sync Drobo's clock to UTC

       setlunsize  Set the size of LUNS on device. Arguments:

	      <sz> integer number of TiB to set the lunsize to

	      <confirmation> Specify 'PleaseEraseMyData' if you really mean it

	      Note: After execution, Drobo reboots, wait a few minutes before accessing again

       shutdown
	      shutdown drobo (DRI calls this 'standby')

       status report how is the Drobo doing

   device
       raw block device of a drobo (i.e. /dev/sdz) . If not given, assumes all attached drobos.

AUTHOR

       This manual page was written by Chris AtLee <chris@atlee.ca> for the Debian project (but may be used by others).

2008								      October								 DROBOM(8)