SHOWKEY(1)						      General Commands Manual							SHOWKEY(1)

NAME

       showkey - examine the codes sent by the keyboard

SYNOPSIS

       showkey [-h|--help] [-a|--ascii] [-s|--scancodes] [-k|--keycodes]

DESCRIPTION

       showkey prints to standard output either the scan codes or the keycode or the `ascii' code of each key pressed.	In the first two modes the
       program runs until 10 seconds have elapsed since the last key press or release event, or until it receives a suitable signal, like SIGTERM,
       from another process.  In `ascii' mode the program terminates when the user types ^D.

       When in scancode dump mode, showkey prints in hexadecimal format each byte received from the keyboard to the standard output. A new line is
       printed when an interval of about 0.1 seconds occurs between the bytes received, or when the internal receive buffer fills up. This can	be
       used  to  determine  roughly,  what byte sequences the keyboard sends at once on a given key press. The scan code dumping mode is primarily
       intended for debugging the keyboard driver or other low level interfaces. As such it shouldn't be of much interest to the regular end-user.
       However,  some  modern  keyboards  have keys or buttons that produce scancodes to which the kernel does not associate a keycode, and, after
       finding out what these are, the user can assign keycodes with setkeycodes(8).

       When in the default keycode dump mode, showkey prints to the standard output the keycode number or each key pressed or released.  The  kind
       of  the	event, press or release, is also reported.  Keycodes are numbers assigned by the kernel to each individual physical key. Every key
       has always only one associated keycode number, whether the keyboard sends single or multiple scan codes when pressing it. Using showkey	in
       this mode, you can find out what numbers to use in your personalized keymap files.

       When in `ascii' dump mode, showkey prints to the standard output the decimal, octal, and hexadecimal value(s) of the key pressed, according
       to he present keymap.

OPTIONS

       -h --help
	      showkey prints to the standard error output its version number, a compile option and a short usage message, then exits.

       -s --scancodes
	      Starts showkey in scan code dump mode.

       -k --keycodes
	      Starts showkey in keycode dump mode. This is the default, when no command line options are present.

       -a --ascii
	      Starts showkey in `ascii' dump mode.

SEE ALSO

       loadkeys(1), dumpkeys(1), keymaps(5), setkeycodes(8)

								    1 Feb 1998								SHOWKEY(1)