If you really do want a monitor attached to your 280 then you will need to install a Sun graphics card, e.g. XVR-100 this comes with a VGA connector although the default resolution is 1152x900 which many monitors do not like so when you set the output-device in the OBP you will also need to set a more standard resolution, e.g.:
As DukeNuke2 mentioned you may want to get some ear plugs as well!
Hello all,
I'm lost and can't figure this problem out.
I have a Sun fire 280R running Solaris 8. Everything was working great. I have one drive in bay 1(not 0). But when I reboot the system it trys to open files in /dev/rdsk/c1t1d0s0. Should it have been opeing /dev/rdsk/c1t0d0s0, the... (4 Replies)
All,
After a power loss I went to power on our sun fire v120 that is running solaris 10 and now it will not boot. I tried power cycling it from the lom and pulling the cord but nothing works. All it does is after a power cycle it will start to boot and then start to spit out a bunch of hex... (2 Replies)
Hello there!
I have Sun Fire 3800 with very old Solaris 9 and I need to perform upgrade to concurrent Solaris 10 version, preserving current OS configuration. I supose to make it using Live Upgrade, but according to Solaris Live Upgrade Software: Minimum Patch Requirements page, I need to... (5 Replies)
Hi:
I bougth an used Sun Fire v440, and It have a firmware password. When I turn on the server, it ask for firmware password. (I don 't know what is the correct password). I can access to SC, but when I want to access to OBP, Firmware Password appears again. I remove the battery for two hours,... (1 Reply)
Hi ,
during 2 weeks i´ve been trying to find them.
i need DCMU packets for managing internal disks on sun fire x4500 and sun fire x4600 on rhel. i have opened to tickets to myoraclesupport but no answer.
please anybody could tell me a link or anythiing?? i´ve been searching and searching... (1 Reply)
:)Dear Solaris Experts,
I need to clone a Solaris 10 x86 system using a ufsdump backup from the following source & target servers:
Sun Fire x2200 M2 with Quad Core Processor
# /usr/platform/`uname -i`/sbin/prtdiag
System Configuration: Sun Microsystems Sun Fire X2200 M2 with Quad Core... (8 Replies)
Hi,
I have a SUN Fire V440 server running Solaris 8. One of the 4 disks do not appear when issued the format command. The "ready to remove" LED is not on either.
Metastat command warns that this disk "Needs maintenace". Can I just shutdown and power off the machine and then insert an... (5 Replies)
Hey Guys I am new here, dont know if any one can assist me with this issue.
I have a Sun-Fire-V490 machine that was upgraded to version 9 and patched a few months back.
Problem is a few network printers managed by the server is printing an extra page that comes out before and after every print... (0 Replies)
cat note
Hi Sun Solaris Experts,
When I try to install Solaris 8 10/00 OS via the Solaris 8 Installation Disk on our Sun Fire V490 Server using the command , I get:
boot: cannot open kernel/sparcv9/unix
which means it can't find the unix kernel file on the installation disk .
By the way, I... (5 Replies)
Hi Solaris/Unix Experts,
I've installed Oracle Solaris 10 1/13 on a Sun Fire V490 Server via its external Serial Port using a Cisco Console Cable connected to my Laptop PC running SecureCRT terminal emulation software emulating VT100 Terminal.
The Sun Fire V490 server has two on-board... (1 Reply)
Discussion started by: ssabet
1 Replies
LEARN ABOUT OPENSOLARIS
cvc
cvc(7D) Devices cvc(7D)NAME
cvc - virtual console driver
DESCRIPTION
The cvc virtual console driver is a STREAMS-based pseudo driver that supports the network console. The cvc driver interfaces with con-
sole(7D).
Logically, the cvc driver sits below the console driver. It redirects console output to the cvcredir(7D) driver if a network console con-
nection is active. If a network console connection is not active, it redirects console output to an internal hardware interface.
The cvc driver receives console input from cvcredir and internal hardware and passes it to the process associated with /dev/console.
NOTES
The cvc facility supersedes the SunOS wscons(7D) facility, which should not be used in conjunction with cvc. The wscons driver is use-
ful for systems with directly attached consoles (frame buffers and keyboards), but is not useful with platforms using cvc, which have no
local keyboard or frame buffer.
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
+--------------------+--------------------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+--------------------+--------------------------------------+
|Architecture |Sun Enterprise 10000 servers, Sun |
| |Fire 15000 servers |
+--------------------+--------------------------------------+
|Availability |SUNWcvc.u |
+--------------------+--------------------------------------+
SEE ALSO cvcd(1M), attributes(5), console(7D), cvcredir(7D), wscons(7D)
Sun Enterprise 10000 SSP Reference Manual
Sun System Management Services (SMS) Reference Manual
SunOS 5.11 15 Sep 2000 cvc(7D)