03-21-2009
Thanks DukeNuke2... I will use that bootable cd and inform if I face any difficulty.. I have found that bootable live cd from the given link... It's latest I think....
Download Search Results
10 More Discussions You Might Find Interesting
1. AIX
Hey Alll
Thanks for the help u give me yesterday,i need a help again from u all guys i have RS 6000 server with AIX 4.3.3 OS and with external storage (multipack) with 12 Hard disk drive which will be connected to RS 6000 scsi controller ,i dont have any raid card. now i have to... (0 Replies)
Discussion started by: solaris8in
0 Replies
2. SCO
recently we have purchased hp proliant ml350 g5 server and configured raid 5 with hp smartarray p200i sas controller.but i could not found any sas raid controller hp smartarry p200i driver for sco unix 5.0.7 :(.i searched on hp support site,but no use.any one can help. (3 Replies)
Discussion started by: prakrithi
3 Replies
3. Solaris
I need to install a raid HBA internal card on a T5240. The reason is I have
more drives and the current mother board controller does not support more
than 4 drives.
My question is I have raidctl set up on current drives. If I install new HBA
card do I have to delete current raidctl and... (3 Replies)
Discussion started by: photon
3 Replies
4. Solaris
Hi all
i would like to ask some suggests about my next job!
I have to install a new Sun Netra T5220, with an additional internal StorageTek SAS HBA Raid.
The problem come in if every disk is now controlled by the HBA, how can I install the OS?
No disk is being detected by the OS.
SAS card... (2 Replies)
Discussion started by: kakabobo
2 Replies
5. Solaris
i was given a task which needs to perform a raid 1 on the boot disk, and 4 other disks on raid 10.
Is there any other alternative in installing solaris 10 other than through network installation?will be using solaris update 6.
while reading through the user guide i got pretty confuse.
... (1 Reply)
Discussion started by: monstar1407
1 Replies
6. Red Hat
We have configured software based RAID5 with LVM on our RHEL5 servers. Please let us know if its good to configure software RAID on live environment servers. What can be the disadvantages of software RAID against hardware RAID (4 Replies)
Discussion started by: mitchnelson
4 Replies
7. AIX
Hello folks,
Could someone tell me why I unable to create pdisks for a RAID Array
# lscfg | grep scsi
+ sisscsia0 U787A.001.DPM0707-P1 PCI-X Dual Channel Ultra320 SCSI Adapter
+ scsi0 U787A.001.DPM0707-P1-T10 PCI-X Dual Channel Ultra320 SCSI Adapter... (12 Replies)
Discussion started by: filosophizer
12 Replies
8. Solaris
Hi !
I've been given a T5240 with 4 disks and 2 HBA cards (but no array connected). I did a factory reset on SP and NVRAM clean on OBP because the server had been used before.
I boot cdrom in single mode and try to create a hw mirror with disks from c1... but only c2 is seen by raidctl.
... (2 Replies)
Discussion started by: delavega
2 Replies
9. Red Hat
Hello,
I want to delete a RAID configuration an old server has.
Since i haven't the chance to work with the specific raid controller in the past can you please help me how to perform the configuraiton?
I downloaded IBM ServeRAID Support CD but i wasn't able to configure the video card so i... (0 Replies)
Discussion started by: @dagio
0 Replies
10. AIX
OSLevel: 5300-10-02-0943
System Model: IBM,8203-E4A
Power 6
==
Hi!
I replaced a failed pdisk in the raid enclosure as follows,
- rmdev -l 'pdisk18' '-d'
- Replaced it.
- cfgmgr (detected)
- I can see the new drive, with the correct serial #
lscfg -v -l pdisk18
pdisk18... (2 Replies)
Discussion started by: estrar
2 Replies
LEARN ABOUT FREEBSD
hptiop
HPTIOP(4) BSD Kernel Interfaces Manual HPTIOP(4)
NAME
hptiop -- HighPoint RocketRAID 3xxx/4xxx device driver
SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file:
device hptiop
device scbus
device da
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
hptiop_load="YES"
DESCRIPTION
The hptiop driver provides support for the HighPoint RocketRAID 3xxx/4xxx series of SAS and SATA RAID controllers.
HARDWARE
The hptiop driver supports the following SAS and SATA RAID controllers:
o HighPoint RocketRAID 4522
o HighPoint RocketRAID 4521
o HighPoint RocketRAID 4520
o HighPoint RocketRAID 4322
o HighPoint RocketRAID 4321
o HighPoint RocketRAID 4320
o HighPoint RocketRAID 4311
o HighPoint RocketRAID 4310
o HighPoint RocketRAID 3640
o HighPoint RocketRAID 3622
o HighPoint RocketRAID 3620
The hptiop driver also supports the following SAS and SATA RAID controllers that are already End-of-Life:
o HighPoint RocketRAID 4211
o HighPoint RocketRAID 4210
o HighPoint RocketRAID 3560
o HighPoint RocketRAID 3540
o HighPoint RocketRAID 3530
o HighPoint RocketRAID 3522
o HighPoint RocketRAID 3521
o HighPoint RocketRAID 3520
o HighPoint RocketRAID 3511
o HighPoint RocketRAID 3510
o HighPoint RocketRAID 3410
o HighPoint RocketRAID 3320
o HighPoint RocketRAID 3220
o HighPoint RocketRAID 3122
o HighPoint RocketRAID 3120
o HighPoint RocketRAID 3020
NOTES
The hptiop driver has only been tested on the i386 and amd64 platforms.
SEE ALSO
cam(4), hptmv(4)
HISTORY
The hptiop device driver first appeared in FreeBSD 7.0.
AUTHORS
The hptiop driver was written by HighPoint Technologies, Inc.
BSD
July 5, 2013 BSD