I have a Realtek 8139 interface in one of my machines and it will not connect to the network. /etc/rc.conf contains ifconfig_rl0="DHCP" and "rl0" was obtained from a dmesg. A network interface restart yields the following:
I have also tried "ifconfig_rl0 up", but without any effect. Anybody know what else to test and configure?
Hi all,
I am experiencing a problem with dhcp broadcast packages. these broadcast packages are seen on bge1 and bge1:1 interfaces but somehow they are not seen at bge771001 interface which is second virtual interface on the bge1 interface.
I have a server on which I configured it as working... (2 Replies)
Hello all :confused:
I am using a Realtek RTL-8185 wireless lan controller on my Dell dimension 4800 to try to connect to the internet. my distro is fedora 11. I go to enable wireless and my computer freezes, I have done some upgrading and building on the computer for a year now but I have... (1 Reply)
Hi,
I have a PC running Solaris 10 (hostname MARKUNIX) and a laptop running WinXP (hostname MARK-LAPTOP).
Both are connected to broadband via a router. IP addresses for each are determined via DHCP (192.168.1.nn) and I do not leave either on, 24x7.
I am running Oracle on MARKUNIX and... (1 Reply)
hi,
can anyone tell me how to check if my interface is controlled by dhcp?
i tried with ifconfig command
ifconfig interfacename dhcp status
but its showing unknown host : dhcp error. (2 Replies)
Hi,
We currently operate a DHCP Server on Vxworks system.
It seems that the server is functioning only over the boot interface.
While trying to use it on a different interface the DHCP client messages seems to reach the interface but stay without response.
From a... (1 Reply)
i need to configure a zone to use different interface (bge2) than global and have connected to completely different network switch & to use its own defaultrouter and hosts file .. is it possible ..if so ..how ?
Thanks (9 Replies)
Hi,
I'm a italian student. For my thesis I develop a gateway with protocol 6lowpan.
For that I must access to network interface to develope my personal stack based on standard 802.15.4.
Can you help me? I need an explanation for that. (0 Replies)
I've one Netra 240
After changing main board and system configuration card reader, Network is not accessible any more, Network interfaces are always UP and Running even when there is no cable connected to Network interfaces.
I tried to restart and plumb/unplumb with no luck.
ifconfig -a... (7 Replies)
Let's say I have a home network containing a server that acts as the resident gateway and serves dhcp and dns requests. Laptop A is frequently connected and disconnected from the network as it is used as a travel computer. Is there a secure way to make sure that whenever laptop A is connected to... (3 Replies)
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)