02-16-2009
Hello,
When you start to see this sort of errors it means most likely that the hard drive is dying.
Some part of the disk has lost informations and sco could NOT recover it.
I would sugest you to relpace that drive.
another possibility is with a drive array with the write back cache enabled is the battery on the controler is dead and the controler lost/corrupted part of the info before comiting it to the drive.
10 More Discussions You Might Find Interesting
1. Filesystems, Disks and Memory
HELP is urgently required,
I run on SCO Unix 3 and this is the panic message that I get every time that I reboot 10U
k_trap - kernel mode trap type 0x0000000E
I have checked the swap already having the following results:
#swap -l
path dev swaplo blocks free... (3 Replies)
Discussion started by: alex_slb
3 Replies
2. UNIX for Dummies Questions & Answers
I've installed rh 7.3 a fewday ago and I'm trying to boot it and I get this" Kernel panic: no init found. try passing init=options to kernel" ????? What do I do.
Thanks.
F,Ruiz. (2 Replies)
Discussion started by: ruizf
2 Replies
3. UNIX for Dummies Questions & Answers
hello :-)
I have one problem with my LiLO... I installed PLD Linux on my computer but when it boots, the last thing I can see is:
request_module Root fs not mounted
VFS: Cannot open root device 03:01
Kernel panic: VFS: unable to mount root fs on 03:01
and the system stops :-(
what... (1 Reply)
Discussion started by: pgas
1 Replies
4. SCO
hi,
I am trying to install sco openserver 5.0.4 on an old system. However, l was not able to proceed after putting the bootstr
l have this panic message of
PANIC: K_trap - kernel mode trap tupe 0x00000006
will someone kindly help to decode this error
kayode (1 Reply)
Discussion started by: kayode
1 Replies
5. Linux
I have compiled kernel version 2.6.12 in my linux box mandrake 10.1. I have followed www.digitalhermit.com/linux/Kernel-Build-HOWTO.html instructions. I have copied .config file from /usr/src/linux and lightly modified it (only the processor type) by xconfig. I have compiled the source and modules.... (3 Replies)
Discussion started by: Davide71
3 Replies
6. Solaris
One of our Sun E450 machines crashed and has this message in the /var/adm/messages after it rebooted automatically. An extract of the log is below. I suspect it is memory, but I am not sure. Can anyone give me any ideas how to diagnose this correctly?
Thanks
Margaret Floyd
Apr 10 08:18:54... (1 Reply)
Discussion started by: floydm
1 Replies
7. Linux
ok so I just installed fedora core 6 on my dell inspiron 700m and I go to boot into linux and I get this error. Has anyone seen this before?
I also had XP Pro and Vista installed on this pc prior to putting fedora core 6 on the machine. I'm trying to setup a triple boot system.
Please Help... (2 Replies)
Discussion started by: dave043
2 Replies
8. SCO
hi
I've virtualized physical SCO 5.0.6 on ESX 4 according to:
Blog du DS45: HOWTO SCO P2V in the real life
SCO starts with the network, but during shutdown I'm getting this message:
PANIC: k_trap.
My /etc/default/boot:
# cat /etc/default/boot
#ScoAdminInit BOOTMNT {RO RW NO} RO... (4 Replies)
Discussion started by: ccc
4 Replies
9. SCO
I shutdown my sco 5.0.7 machine about a month and a half ago and upon bringing it back up got the following kernel panic:
Panic: k_trap - Kernel mode trap type0x0000000E
Unable to freeze processor 2, proceeding....
Cannot dump ?????? pages (I don't remember how many pages it was)
Dump not... (0 Replies)
Discussion started by: powwm
0 Replies
10. UNIX for Advanced & Expert Users
Hi, all:
How should I obtain the reason of kernel panic?
How should I debug the program which result in a kernel panic?
What can I get from the panic information?
li, kunlun (3 Replies)
Discussion started by: liklstar
3 Replies
LEARN ABOUT OPENSOLARIS
mdlogd
mdlogd(1M) System Administration Commands mdlogd(1M)
NAME
mdlogd - Solaris Volume Manager daemon
SYNOPSIS
mdlogd
DESCRIPTION
mdlogd implements a simple daemon that watches the system console looking for messages written by the Solaris Volume Manger. When a Solaris
Volume Manager message is detected, mdlogd sends a generic SNMP trap.
To enable traps, you must configure mdlogd into the SNMP framework. See .
USAGE
mdlogd implements the following SNMP MIB:
SOLARIS-VOLUME-MGR-MIB DEFINITIONS ::= BEGIN
IMPORTS
enterprises FROM RFC1155-SMI
DisplayString FROM SNMPv2-TC;
-- Sun Private MIB for Solaris Volume Manager
sun OBJECT IDENTIFIER ::= { enterprises 42 }
sunSVM OBJECT IDENTIFIER ::= { sun 104 }
-- this is actually just the string from /dev/log that
-- matches the md: regular expressions.
-- This is an interim SNMP trap generator to provide
-- information until a more complete version is available.
-- this definition is a formalization of the old
-- Solaris DiskSuite mdlogd trap mib.
svmOldTrapString OBJECT-TYPE
SYNTAX DisplayString (SIZE (0..255))
ACCESS read-only
STATUS mandatory
DESCRIPTION
"This is the matched string that
was obtained from /dev/log."
::= { sunSVM 1 }
-- SVM Compatibility ( error trap )
svmNotice TrapTRAP-TYPE
ENTERPRISE sunSVM
VARIABLES { svmOldTrapString }
DESCRIPTION
"SVM error log trap for NOTICE.
This matches 'NOTICE: md:'"
::= 1
svmWarningTrap TRAP-TYPE
ENTERPRISE sunSVM
VARIABLES { svmOldTrapString }
DESCRIPTION
"SVM error log trap for WARNING..
This matches 'WARNING: md:'"
::= 2
svmPanicTrap TRAP-TYPE
ENTERPRISE sunSVM
VARIABLES { svmOldTrapString }
DESCRIPTION
"SVM error log traps for PANIC..
This matches 'PANIC: md:'"
::= 3
END
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Availability |SUNWlvma, SUNWlvmr |
+-----------------------------+-----------------------------+
|Interface Stability |Obsolete |
+-----------------------------+-----------------------------+
SEE ALSO
snmpdx(1M), attributes(5)
SunOS 5.11 3 Jun 2004 mdlogd(1M)