EPAIR(4)						   BSD Kernel Interfaces Manual 						  EPAIR(4)

NAME

     epair -- A pair of virtual back-to-back connected Ethernet interfaces.

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel configuration file:

	   device epair

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_epair_load="YES"

DESCRIPTION

     The epair is a pair of Ethernet-like software interfaces, which are connected back-to-back with a virtual cross-over cable.

     Each epair interface pair is created at runtime using interface cloning.  This is most easily done with the ifconfig(8) create command or
     using the cloned_interfaces variable in rc.conf(5).  While for cloning you only give either epair or epair<n> the epair pair will be named
     like epair<n>[ab].  This means the names of the first epair interfaces will be epair0a and epair0b.

     Like any other Ethernet interface, an epair needs to have a network address.  Each epair will be assigned a locally administered address by
     default, that is only guaranteed to be unique within one network stack.  To change the default addresses one may use the SIOCSIFADDR ioctl(2)
     or ifconfig(8) utility.

     The basic intend is to provide connectivity between two virtual network stack instances.  When connected to a if_bridge(4) one end of the
     interface pair can also be part of another (virtual) LAN.	As with any other Ethernet interface one can configure vlan(4) support on top of
     it.

SEE ALSO

     ioctl(2), altq(4), bpf(4), if_bridge(4), vlan(4), loader.conf(5,) rc.conf(5), ifconfig(8)

HISTORY

     The epair interface first appeared in FreeBSD 8.0.

AUTHORS

     The epair interface was written by Bjoern A. Zeeb, CK Software GmbH, under sponsorship from the FreeBSD Foundation.

BSD
								   July 26, 2009							       BSD