Sponsored Content
Full Discussion: Mutiple nics on Freebsd 7.0
Special Forums IP Networking Mutiple nics on Freebsd 7.0 Post 302272531 by linuxbynight on Tuesday 30th of December 2008 09:32:14 PM
Old 12-30-2008
Another take on this might be if you want the secondary nic and lan to be serviced through your bsd server. You might for example want to give the second nic an address within a different subnet (such as 192.168.2.xxx if your netmask is a class C --- 255.255.255.0 or just choose another address/mask combination such as 69.69.69.1/255.255.255.0). You would need to enable routing of this second nic to the outside world. Your clients on this new subnet would have default route set to be your bsd server. All of this also would assume you run a separate physical wire for the second nic to keep the traffic separate. There are also other benefits here if you want to for example to have your bsd server act as the dhcpd server for this secondary lan. Lastly, I am not sure about bsd but LINUX does offer the ability to masquerade so that you could have your bsd server act as the single access point to the outside world. Why do all of this? It does give you the ability to control traffic between your client workstations and the outside world if that is you end goal. The implication/downside is that your bsd server would need to kept online to service the secondary lan clients. Lots of options/fun to play with.
 

10 More Discussions You Might Find Interesting

1. IP Networking

HELP!! NICs went offline suddenly

I have a new server... We were doing some testing on it over the local ethernet. All was well in the night when we turned off the machine. In the morning we were unable to get the server online. Have changed cables, NICs, looked over network settings... all to no avail. I am running Redhat... (4 Replies)
Discussion started by: skotapal
4 Replies

2. AIX

Merge NICs

Hi friends, I installed oracle 10g (10.2.0.2) RAC on 2 IBM p5 570 servers running AIX 5.3ML04 and HACMP5.2 (used Raw devices, not used GPFS). Each server has 4 x 1Gbps ethernet cards (NICs), en0 and en1 for boot address, en2 and en3 for oracle interconnect. Now i want to merge 2 NICs (en2 and... (1 Reply)
Discussion started by: bong02
1 Replies

3. IP Networking

FreeBSD and two NICs

FreeBSD 4.8, Apache 1.3.27 - two NICs, one with a real-world IP plugged into a switch outside the PIX firewall, the other with a private IP plugged into a switch inside the PIX firewall. Apache listens on both IPs. my domain is mydomain.org. so in /etc/rc.conf i have something like this (these... (10 Replies)
Discussion started by: ednix
10 Replies

4. Solaris

How many NICS do I have?

Hi, is there a way in Solaris 8 to determine how many total NIC's say a Sun Sparc box has installed - plumbed or unplumbed - and find out its capable network speeds and MAC address? I know ifconfig -a but that only shows the plumbed and used interfaces. thx cc (2 Replies)
Discussion started by: bigapple100
2 Replies

5. Linux

Two NICs one IP address

I'm looking for a way in RHL 5.1 to use two NICs on one host with two physical IP addresses and map them under one virtual IP address, i.e. NIC 1 10.10.10.1 NIC2 10.10.10.2 VIP 192.168.10.1 Basically I want either one of the NICs to ARP for the VIP. No load balancing required just HA. (2 Replies)
Discussion started by: wschmied
2 Replies

6. Programming

Application crashes in FreeBSD 7.1 while working ok in FreeBSD 6.3

Hello there, My mulithreaded application (which is too large to represent the source code here) is crashing after installing FreeBSD 7.1-RELEASE/amd64. It worked properly on others machines (Dual Cores with 4GB of RAM - FreeBSD 6.2-RELEASE/i386). The current machine has 2x Core 2 Duo... (1 Reply)
Discussion started by: Seenquev
1 Replies

7. UNIX for Dummies Questions & Answers

How to find about NICs installed

Hi; Is there a way to determine for sure how many NIC ports installed on my Linux box? I tried to run "lspci" but not sure about the results, it's not clear. Below are the results when i run both "ifconfig" & "lspci" on my Linux box i hope someone can help me finding the actual numbers of... (1 Reply)
Discussion started by: Katkota
1 Replies

8. Solaris

Redirect to same port two NICs?

Dear members, I have to problems ; First ; I need to setup two NICs for a Solaris 10 server. But I could not do that unless giving different names in /etc/hosts file. like : 10.1.1.1 testsolaris1 10.3.1.1 testsolaris2 Second ; After solving first problem I have to setup my... (3 Replies)
Discussion started by: shadowfaxxxx
3 Replies

9. IP Networking

Networking 2 NICs

Hi all, Host - Ubuntu 12.04 desktop 64bit Virtualizer - Oracle VirtualBox 2 NICs Where can I find relevant document to set up 2 NICs, one for inward bound and another for outward bound, separate channel, both connected to the same router Would following document be appropriate for my... (1 Reply)
Discussion started by: satimis
1 Replies

10. UNIX for Dummies Questions & Answers

Linux with two NICs

Hello All, I have Linux box with two interface cards. Every card has it's own IP Address and Gateway, IP addresses are from different subnets. eth0 192.168.1.10/24 GW 192.168.1.1 eth1 192.168.2.10/24 GW 192.168.2.1 Third PC is located in 192.168.13.0/24 network and is trying to access... (2 Replies)
Discussion started by: AndreiM
2 Replies
netmasks(4)							   File Formats 						       netmasks(4)

NAME
netmasks - network mask database SYNOPSIS
/etc/inet/netmasks /etc/netmasks DESCRIPTION
The netmasks file contains network masks used to implement IP subnetting. It supports both standard subnetting as specified in RFC-950 and variable length subnetting as specified in RFC-1519. When using standard subnetting there should be a single line for each network that is subnetted in this file with the network number, any number of SPACE or TAB characters, and the network mask to use on that network. Network numbers and masks may be specified in the conventional IP `.' (dot) notation (like IP host addresses, but with zeroes for the host part). For example, 128.32.0.0 255.255.255.0 can be used to specify that the Class B network 128.32.0.0 should have eight bits of subnet field and eight bits of host field, in addition to the standard sixteen bits in the network field. When using variable length subnetting, the format is identical. However, there should be a line for each subnet with the first field being the subnet and the second field being the netmask that applies to that subnet. The users of the database, such as ifconfig(1M), perform a lookup to find the longest possible matching mask. It is possible to combine the RFC-950 and RFC-1519 form of subnet masks in the net- masks file. For example, 128.32.0.0 255.255.255.0 128.32.27.0 255.255.255.240 128.32.27.16 255.255.255.240 128.32.27.32 255.255.255.240 128.32.27.48 255.255.255.240 128.32.27.64 255.255.255.240 128.32.27.80 255.255.255.240 128.32.27.96 255.255.255.240 128.32.27.112 255.255.255.240 128.32.27.128 255.255.255.240 128.32.27.144 255.255.255.240 128.32.27.160 255.255.255.240 128.32.27.176 255.255.255.240 128.32.27.192 255.255.255.240 128.32.27.208 255.255.255.240 128.32.27.224 255.255.255.240 128.32.27.240 255.255.255.240 128.32.64.0 255.255.255.192 can be used to specify different netmasks in different parts of the 128.32.0.0 Class B network number. Addresses 128.32.27.0 through 128.32.27.255 have a subnet mask with 28 bits in the combined network and subnet fields (often referred to as the subnet field) and 4 bits in the host field. Furthermore, addresses 128.32.64.0 through 128.32.64.63 have a 26 bits in the subnet field. Finally, all other addresses in the range 128.32.0.0 through 128.32.255.255 have a 24 bit subnet field. Invalid entries are ignored. SEE ALSO
ifconfig(1M), inet(7P) Postel, Jon, and Mogul, Jeff, Internet Standard Subnetting Procedure, RFC 950, Network Information Center, SRI International, Menlo Park, Calif., August 1985. V. Fuller, T. Li, J. Yu, K. Varadhan, Classless Inter-Domain Routing (CIDR): an Address Assignment and Aggregation Strategy, RFC 1519, Network Information Center, SRI International, Menlo Park, Calif., September 1993. T. Pummill, B. Manning, Variable Length Subnet Table For IPv4, RFC 1878, Network Information Center, SRI International, Menlo Park, Calif., December 1995. NOTES
/etc/inet/netmasks is the official SVr4 name of the netmasks file. The symbolic link /etc/netmasks exists for BSD compatibility. SunOS 5.10 7 Jan 1997 netmasks(4)
All times are GMT -4. The time now is 10:39 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy