Both tables T3 and ADSL are mostly the same, except for the default route which is set to T3 or ADSL interface accordingly.
The main table contains all routing information like also T3 and ADSL tables do, but also contains iprules to use specific tables for incoming traffic on T3 or ADSL interface.
The T3 interface is connected with a static IP router to the providers network (and internet). The ADSL interface is connected via a common DSL modem/router.
Dear all,
I am a newbie in solaris and I need your advice.
I have a Solaris version 5.9 installed on Sunfire V240.
I am able to ssh the machine from putty remotely.
My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)
Hi all
I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface?
If you have any ideas, please tell me then. Thank you (2 Replies)
This is my situation
DOS pc serial cable (sl0) Linux Pc eth1
192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router)
I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface.
... (3 Replies)
Solaris-9 server is having one primary IP 10.41.161.14 on qfe0 and 10.41.116.0 on qfe3:1. Traffic is going through virtual interface instead of physical interface. How should I force traffic to go with primary interface.
root@smtsrvn01:/# netstat -nr
Routing Table: IPv4
Destination ... (2 Replies)
Im configuring centos with load balance with ip route and ip rule
Eth0 192.168.1.5
Eth1 192.168.5.128
# ip route
192.168.5.0/24 dev eth1 scope link src 192.168.5.128
192.168.1.0/24 dev eth0 proto kernel scope link src 192.168.1.5
169.254.0.0/16 dev eth1 scope link
# ip route show... (2 Replies)
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
Hello,
I wanted to setup routing certain traffic (http/s) out via a second (faster) interface, like described in the following docs (may not post urls):
linux-ip.net /html/adv-multi-internet.html
thegeekstuff.com /2014/08/add-route-ip-command/
I already had this working years ago on... (0 Replies)