and
after you get the package names with the last command check the versions of cluster software with:
maybe there is an older version of cluster installed or maybe it is only partial installed (the first command will check for this...).
greets,
DN2
Hi DN2,
Thank you very much for your prompt reply. I have followed above commands and found that "SUNWscman" package was installed and it was having 3.2.0,REV=2006.09.26.13.45 as VERSION. I have removed that package and now installing again.
Can you guide me what all things needs to be taken care before moving ahead with configuration with "scinstall" ?
Hi,
I have a Redhat Cluster Suite with 2 nodes, using option "Multicast HeartBeating" on clumembd, whith default IP: 225.0.0.11
The cluster member names are:
# grep node /etc/hosts
192.168.100.1 node1
192.168.100.2 node2
My problem is that the Multicast IP is relating to other network... (1 Reply)
Hi
I'm completely new to Solaris Disk Suite. Where can I go and read up about it. I've seen consultants run the meta- commands, but it doesn't make any sense to me. I would like to learn how it works and how to use it.
Thanks (1 Reply)
I am new to Solaris so please bear with me. I have spent enough time searching to get somewhat of a grip here but I am not sure what to do next. I am trying to grow a file system on a Solaris 8 server.
B_root@server:>df -k
Filesystem kbytes used avail capacity Mounted on... (9 Replies)
Hi,
is it normal, that the IP alias (service IP) can't be seen with ifconfig -a , as eth0:1 for example
the IP is on the node, you can ping it, and open ports for that IP
look at this:
# ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue
link/loopback... (4 Replies)
HI
How can i configure fence_cisco_ucs with redhat cluster suite.
i was trying to configure fencing aganet with red ahat cluster suite
i issued command
# /usr/sbin/fence_vmware_soap -a 172.22.90.61 -l admin -p duc2Cisco -o reboot
then i got below error:
Failed: You have to... (0 Replies)
Discussion started by: bentech4u
0 Replies
LEARN ABOUT DEBIAN
votequorum_leaving
VOTEQUORUM_LEAVING(3) Corosync Cluster Engine Programmer's Manual VOTEQUORUM_LEAVING(3)NAME
votequorum_leaving - Tell other nodes that we are leaving the cluster
SYNOPSIS
#include <corosync/votequorum.h>
int votequorum_leaving(votequorum_handle_t handle);
DESCRIPTION
The votequorum_leaving function is used to tell the other nodes in the cluster that this node is leaving. They will (when the node actually
leaves) reduce quorum to keep the cluster running without this node.
This function should only be called if it is known that the node is being shut down for a known reason and could be out of the cluster for
an extended period of time.
Normal behaviour is for the cluster to reduce the total number of votes, but NOT expected_votes when a node leave the cluster, so the clus-
ter could become inquorate. This is correct behaviour and is ther eto prevent split-brain.
Do NOT call this function unless you know what you are doing.
RETURN VALUE
This call returns the CS_OK value if successful, otherwise an error is returned.
ERRORS
The errors are undocumented.
SEE ALSO votequorum_overview(8), votequorum_initialize(3), votequorum_finalize(3), votequorum_dispatch(3), votequorum_fd_get(3),
corosync Man Page 2009-01-26 VOTEQUORUM_LEAVING(3)