IDIFF(1)                                                      General Commands Manual                                                     IDIFF(1)

NAME

       idiff - compare two images

SYNOPSIS

       idiff [options] image1 image2

DESCRIPTION

       The idiff utility is invoked as follows:

       idiff [options] image1 image2

       Where  input1  and  input2  are  the  names of two image files that should be compared. They may be of any format recognized by OpenImageIO
       (i.e., for which image-reading plugins are available).

       If the two input images are not the same resolutions, or do not have the same number of channels, the comparison will return FAILURE  imme-
       diately and will not attempt to compare the pixels of the two images. If they are the same dimensions, the pixels of the two images will be
       compared, and a report will be printed including the mean and maximum error, how many pixels were above the warning and failure thresholds,
       and whether the result is PASS, WARNING, or FAILURE. For example:

       $ idiff a.jpg b.jpg
       Comparing "a.jpg" and "b.jpg"
         Mean error = 0.00450079
         RMS error = 0.00764215
         Peak SNR = 42.3357
         Max error = 0.254902 @ (700, 222, B)
         574062 pixels (82.1%) over 1e-06
         574062 pixels (82.1%) over 1e-06
       FAILURE

       The  "mean  error"  is the average difference (per channel, per pixel). The "max error" is the largest difference in any pixel channel, and
       will point out on which pixel and channel it was found. It will also give a count of how many pixels were above  the  warning  and  failure
       thresholds.

       The  metadata of the two images (e.g., the comments) are not currently compared; only differences in pixel values are taken into considera-
       tion.

       For a complete description, see /usr/share/doc/libopenimageio-dev/openimageio.pdf.gz.

OPTIONS

       --help Print help message

       -v     Verbose status messages

       -a     Compare all subimages/miplevels

   Thresholding and comparison options
       -fail %g
              Failure threshold difference (0.000001)

       -failpercent %g
              Allow this percentage of failures (0)

       -hardfail %g
              Fail if any one pixel exceeds this error (infinity)

       -warn %g
              Warning threshold difference (0.00001)

       -warnpercent %g
              Allow this percentage of warnings (0)

       -hardwarn %g
              Warn if any one pixel exceeds this error (infinity)

       -p     Perform perceptual (rather than numeric) comparison

   Difference image options
       -o %s  Output difference image

       -od    Output image only if nonzero difference

       -abs   Output image of absolute value, not signed difference

       -scale %g
              Scale the output image by this factor

SEE ALSO

       iconvert(1), igrep(1), iinfo(1), iprocess(1), iv(1), maketx(1), oiiotool(1).

AUTHOR

       OpenImageIO was written by Larry Gritz and the other authors and contributors.

       This manual page was written by IRIE Shinsuke <irieshinsuke@yahoo.co.jp>, for the Debian project (and may be used by others).

                                                                   May 19, 2012                                                           IDIFF(1)