|
|
Sponsored Content
Operating Systems
Solaris
break solaris mirror
Post 302208725 by DukeNuke2 on Tuesday 24th of June 2008 05:05:58 PM
06-24-2008
|
|
9 More Discussions You Might Find Interesting
1. Solaris
Hi everyone.
I have a Sun Solaris box which is running on only one internal disk and obviously that is not a good thing, if the disk should fail. This is a pritty straight forward operation in AIX, where my experties are. I have never done this in solaris and would therefore appriciate any help... (3 Replies)
Discussion started by: sprellari
3 Replies
2. Solaris
Hello,
I am trying to do mirror in solaris 9. I have total 0-7 disks
4 5 6 7
0 1 2 3
Drive 0 and Drive 4 = Boot Drives
Need to Mirror following drives.
Drive 1 and Drive 5 = Need to mirror
Drive 1 was mounted on: /prod1, /prod2, /prod3, /prod4, /prod5.
Then i... (3 Replies)
Discussion started by: deal732
3 Replies
3. HP-UX
Hello again,
We need to install patches to HP-UX B.11.11 but would like to break the mirror it has (with out damaging it) so that in case of failure we can use this a meassure procedure.
Any ideas on how to do this
Thank you! (2 Replies)
Discussion started by: AQG
2 Replies
4. Solaris
Hi All,
How do you know if you need to break the mirror on solaris 8 patch update?
Here's the patch example, 117350-54. On the site, it's just a low type update and not a medium or critical.
Is breaking a mirror a best practice only or really a requirement to some patch?
Thanks,
itik (1 Reply)
Discussion started by: itik
1 Replies
5. Solaris
Hello:
I have a machine built on 2 drives and mirrors have been created to a second set of 2 drives (4 total) on the same platform. SVM.
Might anyone provide guidance to create a second machine by breaking the mirrored set, moving the two mirrors (2) to another machine (same platform type),... (1 Reply)
Discussion started by: 4dailyrunner
1 Replies
6. Linux
Hi Guys,
I have a mirrored LVM volume, and wish to break the mirror leaving only copy1 (effectively removing copy 0).
Here's the config:
# lvs -a -o +devices
lvdata vg01 mwi-ao 2.19T lvdata_mlog 100.00 lvdata_mimage_0(0),lvdata_mimage_1(0)
vg01... (0 Replies)
Discussion started by: badoshi
0 Replies
7. Solaris
hi friends, need help.. it is my first time patching using mirror disk backup approach, not so sure about the steps :confused: how do you detach, patch it, boot it and reattach it ? any kind soul here can advise ? thanks in advance..:)
below is the information from my machine:
Filesystem ... (3 Replies)
Discussion started by: Exposure
3 Replies
8. Solaris
Dear All
I have question and I want some one to answer it ..
in Solaris 10 I have two mirrors as below .. c3t0d0s0 & c3t1d0s0
NAME STATE READ WRITE CKSUM
rpool ONLINE 0 0 0
mirror-0 ONLINE 0 0 0
... (1 Reply)
Discussion started by: top.level
1 Replies
9. AIX
Hello,
aix 5.2, mirrored rootvg on hdisk0 and hdisk1. hdisk0 is dead. I can boot to cd, into sms, into maintenance mode. I can fsck all the various partitions on hdisk1 (the hd4 hd2 hd3, etc...) all is fine. But without the hdisk0 part of the mirror I cannot get the system to boot. ystem hangs on... (6 Replies)
Discussion started by: sshapiro
6 Replies