Fibre channel drivers on RS/6000 aix 5L Post: 302203556

9 More Discussions You Might Find Interesting

1. AIX

Install Fibre Card AIX 5.3

Hello, I have two systems that are being prepared to be SAN attached .. can anyone tell me any specific checks I should perform prior to the cards being installed... I am aware of firmware / OS level and relevant drivers, is there anything else? thanks Chris.

2. AIX

Power6 Virtual Fibre Channel Adapter

Hello, Searched in all IBM Redbooks and on the internet and couldn't find anything about the new feature of POWER 6 which Virtual Fibre ( Fiber ) channel adapter. It is similar to virtual scsi adapter. In my client partition I created the virtual Fibre Adapter mapped it with the VIO...

3. UNIX for Advanced & Expert Users

Can AIX 5.3 - 6 Boot From HP EVA 6000 SAN

Hi There, Has anyone had any luck with or know how to get AIX 5+ to boot from a HP EVA 6000 SAN? The servers used here will be P Class Blades My initial searches on this so far did not bring results so I am guessing this may not be possible on HP SAN's but please let me know if I am...

4. Solaris

USCSICMD ioctl calls for Fibre Channel(FC) devices on Solaris 10?

Hi , I have wrtitten a C program that issues USCSICMD ioctl call to the tape devices attached on solaris sparc 10. I was able to get the required information from all SCSI tape devices attached using the utility. But, whenever it is run on FC attached tape drives , the program returns an error...

5. Hardware

Fibre Channel HBA recommendations?

We will be buying new Xeon E5-based servers for our datacenter and were wondering which Fibre Channel host bus adapters we should select for these. The choices are Emulex or QLogic (8Gb FC HBAs). Anybody have any recommendations on which is the better choice? Thanks in advance.

6. AIX

AIX - Fibre Adapter and IBM Storage

Hello, Just a quick question Usually from a PSERIES if you want to connect to IBM SAN Storage you connect the IBM SAN Storage through a SAN Switch something like this --- however my question Can you connect from Pseries directly to San Storage without SAN Switch what would be...

7. Solaris

Fibre channel link down on booting Solaris server

Hi I had power issue that affected a server, in which I had power ON the server SPARC T1-B3 running solaris 10. After power on the system stops at ok prompt, them I issued the following commands: {0} ok setenv auto-boot? false auto-boot? = false {0} ok reset-all SPARC T3-1B,...

8. AIX

[ASK] - AIX Fibre Channel behavior

Hello all, Let me introduce about the context and my environment. We have an AIX 6.1 system, it has 4 FC channels / > lsdev -Cc adapter | grep fcs fcs0 Available 23-T1 Virtual Fibre Channel Client Adapter fcs1 Available 23-T1 Virtual Fibre Channel Client Adapter fcs2 Available 23-T1...

9. Solaris

Fibre Channel link not ready on Netra 240

Hi, One of my Netra 240 went into hung state and I had to reboot it. I powered it off and tried booting it again but unsuccessful. It is not connected to SAN and have local disks. Not able to boot in failsafe mode too. There are two disks of 72GB, both are mirrored in SVM. It complains about...

LEARN ABOUT NETBSD

mca

MCA(4)							   BSD Kernel Interfaces Manual 						    MCA(4)

NAME

     mca -- introduction to machine-independent MCA bus support and drivers

SYNOPSIS

     mca0 at mainbus?

     options MCAVERBOSE

     Machine-dependent; depends on the bus topology and MCA bus interface of your system. Typical MCA buses are connected directly to the main
     system bus.

DESCRIPTION

     NetBSD includes a machine-independent MCA bus subsystem and several machine-independent MCA device drivers.

HARDWARE

     NetBSD includes machine-independent MCA drivers, sorted by device type and driver name:

   SCSI controllers
	   aha	    Adaptec AHA-1640 SCSI interface

	   esp	    NCR 53C90 SCSI Adapter

   Disk and tape controllers
	   edc	    IBM ESDI Fixed Disk Controller

   Serial interfaces
	   com	    NS8250-, NS16450-, and NS16550-based serial cards.

   Network interfaces
	   tr	    TROPIC based token ring interfaces

	   ate	    Allied-Telesis 1720 Ethernet interface cards

	   we	    WD/SMC WD80x3x Ethernet interface cards and clones

	   le	    SKNET Personal and MC+ Ethernet interface cards

	   elmc     3Com EtherLink/MC (3c523) Ethernet interface

	   ep	    3Com EtherLink III 3c529 Ethernet interface

	   tra	    Tiara LANCard/E and Standard MicroSystems 3016/MC Ethernet interface

SEE ALSO

     aha(4), ate(4), com(4), edc(4), elmc(4), ep(4), esp(4), le(4), ne(4), tr(4), tra(4), we(4)

HISTORY

     The machine-independent MCA subsystem appeared in NetBSD 1.5.

BSD
								   March 3, 2005							       BSD