yes jumpstart is easier. here is my sysidcfg file I use on a JS
this information needs to be stored in a certain directory on the FLASH archive. where is yours stored? it must not be able to read it since you did not set the path in the DVD.
when you created the DVD you should have different slices in there ie s0 s1 etc.. in s1 you should have modified it in /etc/sysidcfg since there is where it will read the information
Hey all,
I'm a newbie to iso files and I just downloaded
the 2 iso files for *cough* ms2003 R2 *cough*
trial software. After I downloaded the iso files
I just dragged them to my burn software gui
and sure enough it burned to dvd 2 iso files.
When I attempted to boot the image using VMware... (0 Replies)
Hi,
I've created a bootable DVD which works fine for earlier versions of Solaris 10 (6/06) and Solaris 9.
But now i've moved to Solaris 10 8/07 and I am getting the NFSv4 prompt at login.
Initially i thought i could surpress this by adding the line
nfs4_domain=dynamic
to my... (0 Replies)
I have created a bootable DVD for X86 using a flash archive, the problem is that I have to specify the location at the beginning of the install.
I have edited the any_machine profile under ./jumpstart_sample to contain the following
install_type flash_install
archive_location ... (4 Replies)
Hi all,
thanks for so many helps in many problems!
Can anyone guide, how to create a bootable cd/dvd from downloaded iso images of CentOS 5? I have collected all the iso in a dvd but it is not booting the system. Any response will be appreciable... (2 Replies)
Hi everyone,
Im new to Solaris and am just about to install Solaris 9 on an old Sparc based machine with Solaris 8.
My friend gave me the ISOs for V9, and now, i have them sitting on my Vista, and i have to start writing bootable CDs of the same. But Im not quite sure how to go about doing... (4 Replies)
Hi, I try to get hands on my new RX2600 HP Servers.
For the cold installation of the HP-UX OS the mapping to the
Internal Bootable DVD is gone in the EFI Shell.
ON one of my two HP RX2600 Servers the entry stays there:
EFI Boot Manager ver 1.10 Firmware ver 2.31
Please select a... (2 Replies)
Hello,
Running AIX 7.1 7100-00-03-1115, trying to make a mksysb image to a dvd drive using mkdvd. My final command looks like this..
mkdvd -e -V rootvg -R -C /usr1/AIXADMIN/mkcd/cd_fs -I /usr1/AIXADMIN/mkcd/cd_images -M /usr1/AIXADMIN/mkcd/mksysbimage -d /dev/cd0 -Y
When i run this... (3 Replies)