Shutdown a system by MAC? Post: 302147442

6 More Discussions You Might Find Interesting

1. Solaris

logs for system shutdown

I am working on a SUN T2000 machine with Solaris 10 running on it. When I checked the system this morning, I found it to be turned off. The lastreboot command showed that the system had been shut down the previous night. I want to find out how the system was shut down. I have run hardware health...

2. UNIX for Advanced & Expert Users

System Shutdown Warning Using SAM

Bump to questions thread, thanks.

3. Windows & DOS: Issues & Discussions

system restarts after shutdown!!

Hello, from last few days my laptop is not whutting down properly.. when ever i ty to shutdown it restarts again.. what may be problem?? antivirus is updated till date.. and i use windows xp sp2.... regards, deepak.

4. Solaris

Shutdown system option

I am working on sunos solaris. I want to know which is good for system shut-down ?

5. Red Hat

shutdown system/myeclipse

Hi All, I have one situation to shut-down the system through shell script.I need script command to shut-down the system and process should end(safe-mode) the MyEclipse.

6. Programming

Problem on capturing system Shutdown

I am having exactly the same problem with https://www.unix.com/programming/129264-application-cleanup-during-linux-shutdown.html but the thread is old and closed. The only difference is that I use sigaction() instead of signal(), which is recommended, as far as I know. This is my code: ...

LEARN ABOUT DEBIAN

setether

SETETHER(8)						      System Manager's Manual						       SETETHER(8)

NAME

       setether - Set the ethernet address for use with DECnet

SYNOPSIS

       setether <if> [<if>...]|all [options]

DESCRIPTION

       Set ethernet MAC address on ethernet adaptors

       This  script should be run at system startup. It will change the ethernet hardware (MAC) address of any or all ethernet interfaces to match
       the DECnet node address. DECnet requires that the MAC address of all ethernet adaptors running the protocol be set approriately.  If you do
       not run setether then you must change the ethernet address in some other way for DECnet to work.
       By  default no ethernet interfaces will have their MAC addresses changed by setether, if you specify all then all interfaces name eth* will
       be changed, otherwise a list of interface names can be specified.  setether will enable (UP) all interfaces it changes  the  MAC  addresses
       of.
       (2.4  only) The first interface specified on the command-line will also be made the default interface for DECnet operations (ie attempts to
       contact nodes not in the neighbour table will be done over this interface).
       This script must be run with the interface inactive, it is normally run from /etc/init.d/decnet before TCP/IP starts up.

EXAMPLES

       set the MAC address of eth0.

	   # /sbin/setether eth0

       set the MAC address of all ethernet interfaces

	   # /sbin/setether all

HELPFUL HINTS

       If you have multiple ethernet cards on your system and they are connected to the the same network you should specify which one you want	to
       use  for DECnet communication on the setether command line, otherwise they will both be given the same MAC address and this is probably not
       what you want.
       Running DECnet on multiple ethernet interfaces only works under Linux 2.4. If you are running Linux 2.2 then  the  interface  name  on  the
       setether command line must match the one in /etc/decnet.conf(5).

SEE ALSO

       decnet.conf(5), dntype(1), dndir(1), dndel(1), dnetd(8), dnping(1)

DECnet utilities						   March 01 2001						       SETETHER(8)