01-02-2007
Off hand I'd say you have a driver problem. Look for an update or the one needs with what ever it is your running....
Last edited by jimmyc; 01-02-2007 at 01:43 PM..
10 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Hi, dear all, I am rather new to Unix and have this problem where I cant seem to ping from 1 host to another. The scenerio is as follows: -
1 QNX host->Eth->1 SCO host
the SCO host is configured with it's IP
the QNX host is configured with another IP
both in the same domain, ie, 172.20.3.XX... (3 Replies)
Discussion started by: gavon
3 Replies
2. UNIX for Dummies Questions & Answers
I have Sco openserver 5.0. It had a 125. ip. I changed it to a 192. ip. was unable to ping the 192. I was told to change it in the
etc/tcp
etc/hosts
files which i did. still unable to ping.
i am getting a message unable to route to host.
I also have an error in my etc/tcp file on line... (1 Reply)
Discussion started by: pdoug76
1 Replies
3. UNIX for Dummies Questions & Answers
HI,
I am new to unix. I have used some basic commands and written some simple shell scripts in teh past. Currently, I am supposed to write a script to continuosly check if a couple of machines are up and if not to start a script. I am using a bash - 2.03. I have tryying to use the ping command... (3 Replies)
Discussion started by: swepaul
3 Replies
4. IP Networking
We are unable to bring one of our linux boxes into the network once it was restarted. But once we stop and start the network service. We are able to ping the gateway and get into network. After a minute or two we get the following reponse for the ping command
64 bytes from 124.168.215.40:... (6 Replies)
Discussion started by: chrisanto_2000
6 Replies
5. Solaris
hi,
I setup a Solaris machine in my server room and my client cannot access it. Can anyone advise?
Test that i have done:
-My client pc cannot ping the server.
-My solaris server cannot ping client
-My solaris server can ping it's gateway
-Another NT machine 1 (10.179.30.26) in the server... (2 Replies)
Discussion started by: skiturn
2 Replies
6. IP Networking
hi,
I setup a Solaris machine in my server room and my client cannot access it. Can anyone advise?
Test that i have done:
-My client pc cannot ping the server.
-My solaris server cannot ping client
-My solaris server can ping it's gateway
-Another NT machine 1 (10.179.30.26) in the... (8 Replies)
Discussion started by: skiturn
8 Replies
7. Solaris
Hi ALL,
I Have installed NEW v240 server through hyper terminal, After installation i unable to ping the server from out side server... i can see no entry in resolve.conf file.. but the server has DNS.. willl that issue.. please guide me ping the server from outside within the same network
bk (1 Reply)
Discussion started by: suresh_krish
1 Replies
8. Solaris
Hello,
Am unable to ping the Windows Box, from my Solaris Box.
They both are in same LAN, have the same IP Segments.
Windows IP :: 10.141.14.120
Solaris IP :: 10.141.14.11
Unable to get why isnt working out.... When using the command 'ping 10.141.14.120', it gives the error as 'ping:... (4 Replies)
Discussion started by: jayanto
4 Replies
9. AIX
Hi all,
I have gone through many posts related to this issue,but my issue wasn't resolved hence creating new thread.
I am unable to ping localhost.
ping localhost tries to ping localhost which is defined in DNS.
My /etc/hosts has entry for localhost as
127.0.0.1 loopback localhost.
... (8 Replies)
Discussion started by: chpsam
8 Replies
10. UNIX for Advanced & Expert Users
I have setup a Linux machine on my server but for some reason Im unable to reach my default gateway. This is causing me to not communicate with the outside world (unable to connect to CentOS repos)
# ifconfig
enp0s3: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet... (3 Replies)
Discussion started by: Junaid Subhani
3 Replies
LEARN ABOUT OPENSOLARIS
usoc
usoc(7D) Devices usoc(7D)
NAME
usoc - universal serial optical controller for Fibre Channel arbitrated loop (SOC+) device driver
DESCRIPTION
The Fibre Channel adapter is an SBus card that implements two full duplex Fibre Channel interfaces. Each interface can connect to a Fibre
Channel arbitrated loop (FC-AL). The usoc device driver is a nexus driver and implements portions of the FC-2 and FC-4 layers of FC-AL.
FILES
/kernel/drv/usoc
32-bit ELF kernel module
/kernel/drv/sparcv9/usoc
64-bit ELF kernel module
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Architecture |SPARC |
+-----------------------------+-----------------------------+
|Interface stability |Unknown |
+-----------------------------+-----------------------------+
|Availability |SUNWusoc |
+-----------------------------+-----------------------------+
SEE ALSO
fctl(7D), sbus(4), fcp(7D), fp(7D), ssd(7D)
Writing Device Drivers
Fibre Channel Physical and Signaling Interface (FC-PH) ANSI X3.230: 1994
Fibre Channel Arbitrated Loop (FC-AL) ANSI X3.272-1996
Fibre Channel Private Loop SCSI Direct Attach (FC-PLDA) NCITS TR-19:1998
Fabric Channel Loop Attachment (FC-FLA), NCITS TR-20:1998
DIAGNOSTICS
The following messages are logged and may also appear on the system console. On the console these messages are preceded by:
usoc%d:
where
usoc%d:
is the per-port instance number of the usoc controller.
Fibre Channel is ONLINE
The Fibre Channel loop is now online.
Fibre Channel Loop is ONLINE
The Fibre Channel loop is now online.
Fibre Channel Loop is OFFLINE
The Fibre Channel loop is now offline.
attach failed: device in slave-only slot.
Move soc+ card to another slot.
attach failed: alloc soft state.
Driver did not attach, devices will be inaccessible.
attach failed: bad soft state.
Driver did not attach, devices will be inaccessible.
attach failed: unable to map eeprom
Driver was unable to map device memory; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
attach failed: unable to map XRAM
Driver was unable to map device memory; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
attach failed: unable to map registers
Driver was unable to map device registers; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
attach failed: unable to access status register
Driver was unable to map device registers; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
attach failed: unable to install interrupt handler
Driver was not able to add the interrupt routine to the kernel. Driver did not attach to device, devices will be inaccessible.
attach failed: unable to access host adapter XRAM
Driver was unable to access device RAM; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
attach failed: unable to write host adapter XRAM
Driver was unable to write device RAM; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
attach failed: read/write mismatch in XRAM
Driver was unable to verify device RAM; check for bad hardware. Driver did not attach to device, devices will be inaccessible.
SunOS 5.10 20 Jul 1999 usoc(7D)