1. UNIX for Dummies Questions & Answers

If I use the "Mail" link instead of the "mail" link to ../mailx I get this error. Mail so-n-so @whatever.com mailx: NUL changed to @ Unknown command: "postmaster" The email still goes through but i get the error. If I use "mail" it goes thru without the error. Any ideas?? (2 Replies)

2. Solaris

Hi Community, I've a problem with an interface of my Sun Workstation: when I try to plumb hme0 interface I see this output: # ifconfig hme0 <ip_address> netmask <mask> plumb #ifconfig: plumb: hme0: no such interface I've the same thing with dhcp service. could you provide any solution... (1 Reply)

3. IP Networking

Hi, ifconfig -a return: eth0 Link encap:Ethernet HWaddr 00:09:3D:12:9D:5A inet addr:172.19.208.7 Bcast:172.19.208.63 Mask:255.255.255.192 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:211478649 errors:0 dropped:0 overruns:0 frame:0 ... (5 Replies)

4. Shell Programming and Scripting

Hi All, Can anyone please provide the command for sending an mail with attachment using mailx command. Thanks in Advance :) Regards, Siram. (3 Replies)

5. Solaris

Dear all, I am a newbie in solaris and I need your advice. I have a Solaris version 5.9 installed on Sunfire V240. I am able to ssh the machine from putty remotely. My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)

6. SCO

Hi all I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface? If you have any ideas, please tell me then. Thank you (2 Replies)

7. IP Networking

This is my situation DOS pc serial cable (sl0) Linux Pc eth1 192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router) I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface. ... (3 Replies)

8. UNIX for Dummies Questions & Answers

Hi All, How to check whether a Interface has a single port or dual port.Thanks in advance. (5 Replies)

9. UNIX for Dummies Questions & Answers

I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)